On 03/23/2016 09:45 AM, Uwe Kleine-König wrote:
On Wed, Mar 23, 2016 at 12:44:40AM +0300, Sergei Shtylyov wrote:
The driver of course "knows" that the chip's reset signal is active low,
so it drives the GPIO to 0 to reset the PHY and to 1 otherwise; however
all this will only work iff the GPIO is specified as active-high in the
device tree! I think both the driver and the device trees (if there are
any -- I was unable to find them) need to be fixed in this case...
Fixes: 13a56b449325 ("net: phy: at803x: Add support for hardware reset")
Signed-off-by: Sergei Shtylyov <sergei.shtyl...@cogentembedded.com>
---
The patch is against DaveM's 'net.git' repo.
Don't you need to work against net-next for non-urgent stuff? Or do you
consider this urgent?
The net-next.git is not for fixes, net.git is. And net-next is closed
right now because of the merge window.
drivers/net/phy/at803x.c | 6 +++---
1 file changed, 3 insertions(+), 3 deletions(-)
Index: net/drivers/net/phy/at803x.c
===================================================================
--- net.orig/drivers/net/phy/at803x.c
+++ net/drivers/net/phy/at803x.c
@@ -277,7 +277,7 @@ static int at803x_probe(struct phy_devic
if (!priv)
return -ENOMEM;
- gpiod_reset = devm_gpiod_get_optional(dev, "reset", GPIOD_OUT_HIGH);
+ gpiod_reset = devm_gpiod_get_optional(dev, "reset", GPIOD_OUT_LOW);
if (IS_ERR(gpiod_reset))
return PTR_ERR(gpiod_reset);
@@ -362,10 +362,10 @@ static void at803x_link_change_notify(st
at803x_context_save(phydev, &context);
- gpiod_set_value(priv->gpiod_reset, 0);
- msleep(1);
gpiod_set_value(priv->gpiod_reset, 1);
msleep(1);
+ gpiod_set_value(priv->gpiod_reset, 0);
+ msleep(1);
The new variant is better than the old one. The change however breaks
existing device trees which is not so nice. Given there are no mainline
users this is probably ok though. So:
Acked-by: Uwe Kleine-König <u.kleine-koe...@pengutronix.de>
Thank you!
MBR, Sergei
