I did exactly that when I called. One is looking into the other hasn't called yet. I will let you know what they say.
On Wed, May 16, 2018 at 12:59 PM Phil Lavin <phil.la...@cloudcall.com> wrote: > Ask if they will configure BFD for you. I’ve not found many transit > providers that will, but it’s worth a shot and it will lower failure > detection to circa 1 second. > > > > On 16 May 2018, at 17:49, Adam Kajtar <akaj...@wadsworthcity.org> wrote: > > > > I could use static routes but I noticed since I moved to full routes I > have > > had a lot fewer customer complaints about latency(especially when it > comes > > to Voice and VPN traffic). > > > > I wasn't using per-packet load balancing. I believe juniper default is > per > > IP. > > > > My timers are as follows > > Active Holdtime: 90 > > Keepalive Interval: 30 > > > > Would I be correct in thinking I need to contact my ISP to lower these > > values? > > > > An interesting note is when I had both ISPs connected into a single MX104 > > the failover was just a few seconds. > > > > Thanks again. > > > > > > > >> On Tue, May 15, 2018 at 8:42 PM Ben Cannon <b...@6by7.net> wrote: > >> > >> Have you checked your timeouts ? > >> > >> -Ben > >> > >>> On May 15, 2018, at 4:09 PM, Kaiser, Erich <er...@gotfusion.net> > wrote: > >>> > >>> Do you need full routes? What about just a default route from BGP? > >>> > >>> Erich Kaiser > >>> The Fusion Network > >>> er...@gotfusion.net > >>> Office: 815-570-3101 > >>> > >>> > >>> > >>> > >>>> On Tue, May 15, 2018 at 5:38 PM, Aaron Gould <aar...@gvtc.com> wrote: > >>>> > >>>> You sure it doesn't have something to do with 60 seconds * 3 = 180 > secs > >> of > >>>> BGP neighbor Time out before it believes neighbor is dead and remove > >> routes > >>>> to that neighbor? > >>>> > >>>> Aaron > >>>> > >>>>> On May 15, 2018, at 9:10 AM, Adam Kajtar <akaj...@wadsworthcity.org> > >>>> wrote: > >>>>> > >>>>> Hello: > >>>>> > >>>>> I'm running two Juniper MX104s. Each MX has 1 ISP connected running > >>>>> BGP(full routes). iBGP is running between the routers via a two port > >> 20G > >>>>> lag. When one of the ISPs fails, it can take upwards of 2 minutes for > >>>>> traffic to start flowing correctly. The router has the correct route > in > >>>> the > >>>>> routing table, but it doesn't install it in the forwarding table for > >> the > >>>>> full two mins. > >>>>> > >>>>> I have a few questions if anyone could answer them. > >>>>> > >>>>> - What would a usual convergence time be for this setup? > >>>>> - Is there anything I could do speed this process up? (I tried > >>>> Multipath) > >>>>> - Any tips and tricks would be much appreciated > >>>>> > >>>>> Thanks in Advance > >>>>> -- > >>>>> Adam Kajtar > >>>>> Systems Administrator > >>>>> City of Wadsworth > >>>>> akaj...@wadsworthcity.org > >>>>> ----------------------------------------------------- > >>>>> http://www.wadsworthcity.com > >>>>> > >>>>> Facebook <http://www.facebook.com/cityofwadsworth>* |* Twitter > >>>>> <https://twitter.com/CityOfWadsworth> *|* Instagram > >>>>> <https://www.instagram.com/cityofwadsworth/> *|* YouTube > >>>>> <https://www.youtube.com/channel/UCymlH-AZgvxTaHtgp3-AmDQ> > >>>> > >>>> > >> > > > > > > -- > > Adam Kajtar > > Systems Administrator, Safety Services > > City of Wadsworth > > Office 330.335.2865 > > Cell 330.485.6510 > > akaj...@wadsworthcity.org > > ----------------------------------------------------- > > http://www.wadsworthcity.com > > > > Facebook <http://www.facebook.com/cityofwadsworth>* |* Twitter > > <https://twitter.com/CityOfWadsworth> *|* Instagram > > <https://www.instagram.com/cityofwadsworth/> *|* YouTube > > <https://www.youtube.com/channel/UCymlH-AZgvxTaHtgp3-AmDQ> > -- Adam Kajtar Systems Administrator, Safety Services City of Wadsworth Office 330.335.2865 Cell 330.485.6510 akaj...@wadsworthcity.org ----------------------------------------------------- http://www.wadsworthcity.com Facebook <http://www.facebook.com/cityofwadsworth>* |* Twitter <https://twitter.com/CityOfWadsworth> *|* Instagram <https://www.instagram.com/cityofwadsworth/> *|* YouTube <https://www.youtube.com/channel/UCymlH-AZgvxTaHtgp3-AmDQ>
