I have some use cases where I have Fortinet firewalls running full ospf/ospfv3/bgp and it all pretty much just works without any issues. The CLI is a bit cumbersome, but apart from that its fine.
-----Original Message----- From: NANOG [mailto:nanog-boun...@nanog.org] On Behalf Of Craig Sent: Monday, 9 February 2015 2:21 p.m. To: David Jansen Cc: nanog group Subject: Re: Dynamic routing on firewalls. Setup a multi tenant setup between Nexus 7K and Juniper Net screen 5400 FW using OSPF. It went OK and worked. However when under traffic load/ less than. Desirable results... OSPF peer failure / bounces etc. However using BGP with Juniper SRX FW has been working great. No issues thus far. On Feb 5, 2015 9:11 AM, "David Jansen" <da...@nines.nl> wrote: > Hi, > > We have used dynamic routing on firewall in the old days. We did > experience several severe outages due to this setup (OSPF en Cisco). > As you will understand i’m not eager to go back to this solution but I > am curious about your point of views. > > Is it advisory to so these days? > > Kind regards, > David > > >
