I'm new to linux i decided to to start using it as a mythtv box. I followed the howto on wilsonet.com to install it on fedora. I installed it fine and setup xmltv and then i purchased the PVR 150 model 1024 from newegg.com. I downloaded and installed IvTv using yum and atrpms for fedora core 3 at-bleeding. Then i followed the other instructions in the howto guide to modify the modprobe.conf and start ivtv. I started the mythtvsetup and I chose the standard V4L capture card and video 0. Then i finished the rest of the setup and i exited. I went into the mythtv frontend and i hit watch tv and i was greeted by a black screen. I tried pressing Esc and it would not exit. I was forced to restart. Upon restart i ran setup again and it did not detect Video0 so i exited then started ivtv and then ran setup again and it detected video0 but it apparently found 2tv tuners 2svideo ports and 3 composite ports and i only have 1 tuner, 1svideo, 1 composite. Heres my ivtv log Jun 29 14:33:19 localhost kernel: ivtv: ==================== START INIT IVTV ==================== Jun 29 14:33:19 localhost kernel: ivtv: version 0.3.5 (l) loading Jun 29 14:33:19 localhost kernel: ivtv: Linux version: 2.6.11-1.27_FC3 686 REGPARM 4KSTACKS gcc-3.4 Jun 29 14:33:19 localhost kernel: ivtv: In case of problems please include the debug info Jun 29 14:33:19 localhost kernel: ivtv: between the START INIT IVTV and END INIT IVTV lines when Jun 29 14:33:19 localhost kernel: ivtv: mailing the ivtv-devel mailinglist. Jun 29 14:33:19 localhost kernel: ivtv: Autodetected WinTV PVR 150 card Jun 29 14:33:19 localhost kernel: ivtv: Found an iTVC16 based chip Jun 29 14:33:19 localhost kernel: ACPI: PCI interrupt 0000:00:0e.0[A] -> GSI 10 (level, low) -> IRQ 10 Jun 29 14:33:19 localhost kernel: ivtv: Unreasonably low latency timer, setting to 64 (was 32) Jun 29 14:33:19 localhost kernel: ivtv: XXX PCI device: 0x0730 vendor: 0x1039 Jun 29 14:33:19 localhost kernel: tveeprom: Hauppauge: model = 26552, rev = B268, serial# = 7970919 Jun 29 14:33:20 localhost kernel: tveeprom: tuner = LG TAPE H001F MK3 (idx = 68, type = 47) Jun 29 14:33:20 localhost kernel: tveeprom: tuner fmt = NTSC(M) (eeprom = 0x08, v4l2 = 0x00001000) Jun 29 14:33:20 localhost kernel: tveeprom: audio_processor = MSP3410D (type = 5) Jun 29 14:33:20 localhost kernel: ivtv: i2c attach [client=tveeprom[50],ok] Jun 29 14:33:20 localhost kernel: ivtv: Tuner Type 47, Tuner formats 0x00001000, Radio: yes, Model 0x00892598, Revision 0x00000001 Jun 29 14:33:21 localhost kernel: ivtv: Radio detected Jun 29 14:33:21 localhost kernel: tuner: Ignoring new-style parameters in presence of obsolete ones Jun 29 14:33:21 localhost kernel: tuner: chip found at addr 0xc2 i2c-bus ivtv i2c driver #0 Jun 29 14:33:21 localhost kernel: ivtv: i2c attach [client=(tuner unset),ok] Jun 29 14:33:22 localhost kernel: cx25840: Unable to open FW file '/lib/modules/HcwMakoA.ROM'. Jun 29 14:33:22 localhost kernel: cx25840: Failed to load any FW image file Jun 29 14:33:22 localhost kernel: ivtv: i2c attach [client=cx25840[50],ok] Jun 29 14:33:22 localhost kernel: ivtv: i2c attach [client=wm8775[50],ok] Jun 29 14:33:22 localhost kernel: ivtv: Encoder revision: 0x02040024 Jun 29 14:33:22 localhost kernel: ivtv: Encoder Firmware may be buggy, use version 0x02040011 Jun 29 14:33:22 localhost kernel: ivtv: Configuring WinTV PVR 150 card with 5 streams Jun 29 14:33:22 localhost kernel: ivtv: Registered v4l2 device, streamtype 0 minor 0 Jun 29 14:33:22 localhost kernel: ivtv: Create DMA stream 0 using 128 16384 byte buffers 0 kbytes total Jun 29 14:33:22 localhost kernel: ivtv: Registered v4l2 device, streamtype 1 minor 32 Jun 29 14:33:22 localhost kernel: ivtv: Create DMA stream 1 using 97 21600 byte buffers 0 kbytes total Jun 29 14:33:22 localhost kernel: ivtv: Registered v4l2 device, streamtype 2 minor 224 Jun 29 14:33:22 localhost kernel: ivtv: Create DMA stream 2 using 60 34656 byte buffers 0 kbytes total Jun 29 14:33:22 localhost kernel: ivtv: Registered v4l2 device, streamtype 3 minor 24 Jun 29 14:33:22 localhost kernel: ivtv: Create DMA stream 3 using 455 4608 byte buffers 0 kbytes total Jun 29 14:33:22 localhost kernel: ivtv: Registered v4l2 device, streamtype 4 minor 64 Jun 29 14:33:22 localhost kernel: ivtv: Create stream 4 Jun 29 14:33:22 localhost kernel: ivtv: Setting Tuner 47 Jun 29 14:33:22 localhost kernel: tuner: type set to 47 (LG NTSC (TAPE series)) by ivtv i2c driver #0 Jun 29 14:33:22 localhost kernel: ivtv: Switching standard to NTSC. Jun 29 14:33:22 localhost kernel: ivtv: Initialized WinTV PVR 150, card #0 Jun 29 14:33:22 localhost kernel: ivtv: ==================== END INIT IVTV ====================
Thanks for any help in advance, Paul _______________________________________________ mythtv-users mailing list [email protected] http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-users
