Hallo,
William Lum wrote:
Hi,
I looked in /proc/scsi/advansys and there is a file 13:
AdvanSys SCSI 3.4: PCI Ultra: IO 0xAE00-0xAE0F, IRQ 0x15
Device Information for AdvanSys SCSI Host 13:
Target IDs Detected: 2, (2=Host Adapter)
[...]
Does this mean it's loaded?
It looks at least good. It means that the PCI Switch on the card works.
In the SCSI file shows:
Attached devices:
Host: scsi1 Channel: 00 Id: 00 Lun: 00
Vendor: ATA Model: SAMSUNG SSD PM83 Rev: 3D1Q
Type: Direct-Access ANSI SCSI revision: 05
Tried to load the module and didn't see an error... Looked at boot.log:
Generating locales...
en_US.UTF-8... done
Generation complete.
Found label 'Ubuntu 15.04 _Vivid Vervet_ - Release amd64 (20150422)'
This disc is called:
'Ubuntu 15.04 _Vivid Vervet_ - Release amd64 (20150422)'
Starting Wait for Plymouth Boot Screen to Quit...
[...]
Don't know if this helps?
Did you also try to load the modules for the buz as I did describe, and
look at the output of the kernel ? That would be more interesting.
Some commands like:
modprobe i2c-core
modprobe i2c-algo-bit
modprobe saa7111
modprobe saa7185
modprobe zr36060
You might need to replace the modprobe with insmod, and add .ko to the
module name.
On 3/27/21, Bernhard Praschinger <shadowl...@utanet.at> wrote:
Hallo,
William Lum wrote:
Yes my card does have the SCSI connector for the external drive which I
don't use and the 15 pin for the breakout box.
Is the SCSI Adapter recognized in the system ?
The PCI Bridge ist the National Pico|Power IC. The Advansys should be
the SCSI controller.
Is the driver already loaded ?
Take a look in /proc/scsi there should be scsi file you can view.
Or you try loading the driver for the SCSI controller:
insmod or modprobe advansys
When you load the module it would be good to check if the kernel writes
something to /var/log/messages
When you say switch is it physical? Do I need to set it to a certain
config?
I don't know if there is a possibility to set anything.
When you search the /var/log/boot.log and /var/log/boot.msg
do you find any hints about the buz, advansys or zoran ?
dmesg lets you view the boot messages (probably a file in /var/log) any
hint about the zoran and the driver would be very helpful.
auf hoffentlich bald,
Berni the Chaos of Woodquarter
Email: shadowl...@utanet.at
www: http://www.lysator.liu.se/~gz/bernhard
_______________________________________________
Mjpeg-users mailing list
Mjpeg-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/mjpeg-users
