Hallo > When I record using lavrec from my tv card (ATI TV-Wonder PCI) it is > fine the first time that I record. However, if I try to record a second > time, I cannot get any audio. After recording, I have to start xawtv and > reset the volume on it, as it is then set to zero (not muted, just > turned down to zero). After I do that, I can record with audio again. > > This is the command line that I am using: > lavrec --use-read -i n -q 50 -s -l 90 -R c -f q -g 320x240 -t 10 -v 1 > --file-flush=0 --software-encoding "test.qt"
Does it work if you tell lavrec not to change (-l -1) the mixer registers ? Which soundcard, soundsystem (ALSO/OSS) do you use ? > The output to the terminal does not indicate any errors and the output > to test.qt is fine for both audio, video and sync. It is only in > subsequent attempts that this becomes a problem. > > Is there some way that I can get lavrec to return the volume to normal > after it ceases recording? Telling lavrec not to chanhe the register, could prevent that. But you have to make soure before you record, that you have set up the correct mixer value. auf hoffentlich bald, Berni the Chaos of Woodquarter Email: [EMAIL PROTECTED] www: http://www.lysator.liu.se/~gz/bernhard ------------------------------------------------------- This sf.net email is sponsored by:ThinkGeek Welcome to geek heaven. http://thinkgeek.com/sf _______________________________________________ Mjpeg-users mailing list [EMAIL PROTECTED] https://lists.sourceforge.net/lists/listinfo/mjpeg-users
