> Date: Sun, 5 Jul 2009 07:30:58 -0400 > From: "Hendrickson, Kenneth" <khend...@harris.com> > > > Unfortunately I cannot see your attachments.. > > as the lists do not permit them. > > I will post them in this message. > However, I cannot post OpenBSD.PBR because it is a binary file. > > > As this is a strictly a recovery operating, > > I would like to run OpenBSD on my D201GLY motherboard. > It is not strictly a recovery operation. > > During booting, the kernel dies very shortly after printing "cpu0 at > mainbus0". > However, it boots just fine from the install CD.
Given the fact that the machine boots just fine from the CD you could try the following: 1. Boot from CD; interrupt the bootloader. 2. type "boot hd0a:/bsd" If that doesn't work, you can try disabling device drivers. 1. Boot from disk; interrupt the bootloader. 2. type "boot /bsd -c" 3. at the UKC> prompt type "disable <driver>" I'd start with disabling all the ACPI crap: acpitimer acpihpet acpiac acpibat acpibtn acpicpu acpidock acpiec acpivideo acpivout acpipwrres Other drivers that are worth trying are: azalia ohci ehci
