On Sat, Nov 15, 2008 at 5:37 AM, Jacob Meuser <[EMAIL PROTECTED]> wrote: > On Sat, Nov 15, 2008 at 04:25:49AM +0000, Bryan wrote: >> Greetings, >> >> I just inherited a Dell Inspiron 1520 a few days ago, and I was eager >> to install -current on it. I installed the November 6th snapshot. >> Sadly, I found that this laptop uses the azalia(4) driver. (my >> Inspiron 9300 uses auich(4) ). >> >> So far, I can hear audio in my headphones, and saw the mixerctl switch >> headphone outputs when I plug in headphones. Still can't get the >> microphone to work, > > some hints in your mixerctl below > >> and I still have not been able to hear music from >> the CD player. > > the CD pin isn't connected on this audio codec. use 'cdio cdplay'. > **embarassment** sonofabitch... many apologies. Back in the day, I'd just type in "cdio play", and it would work. It's been a while since I've done that...
>> I saw on the daily changelog that the S/PDIF has been applied, but was >> not sure of the other patches... > > there are more coming ... even if your device starts working, please > keep testing patches to make sure it doesn't stop working ;) > >> I noticed that the replies given have HD Audio cards that are >> different than mine. MIne has the following for output: >> >> azalia0 at pci0 dev 27 function 0 "Intel 82801H HD Audio" rev 0x02: >> apic 2 int 21 (irq 9) >> azalia0: codecs: Sigmatel/0x76a0, Conexant/0x2c06, using Sigmatel/0x76a0 >> audio0 at azalia0 > > this is an STAC9205. http://www.idt.com/index.cfm?genID=STAC9205 > There it is! Wasn't sure what to make of it... >> # mixerctl -av >> outputs.headphones.sour=dac [ dac dac2 ] >> outputs.headphones.dir=output [ input output ] >> outputs.headphones.boos=off [ off on ] >> outputs.line.source=dac [ dac dac2 ] >> outputs.line.dir=input [ input output ] >> outputs.speaker.dir=input [ input output ] >> outputs.speaker.boost=off [ off on ] > > you probably want to set outputs.{line,speaker}.dir=output > I can hear sound. I played a AVI through mplayer, and could hear the sound. What do I need to set line to "output" >> inputs.dac.mute=off [ off on ] >> inputs.dac=160,160 >> inputs.dac2.mute=off [ off on ] >> inputs.dac2=126,126 >> inputs.sel.source=headphones [ line speaker headphones ] >> outputs.sel=126,126 >> inputs.sel2.source= [ line speaker headphones ] >> outputs.sel2=252,252 >> inputs.sel3.sel=119,119 >> inputs.sel4.sel2=119,119 >> inputs.sel5.source=sel3 [ sel3 mic ] >> outputs.sel5.mute=off [ off on ] >> inputs.sel6.source=sel4 [ sel4 mic ] > > inputs.sel{5,6}.source=mic > Thanks for the tip. I'll keep this e-mail for future reference... >> outputs.sel6.mute=off [ off on ] >> inputs.beep=85 >> outputs.volume=254 >> inputs.usingdac=10 [ 10 11 1f ] >> record.usingadc=12 [ 12 13 20 ] >> outputs.master=160,160 >> inputs.dac=160,160 >> > I am downloading the source for -current, and will patch for the azalia(4) patches when they become available.
