Rolf Sommerhalder wrote:
Any other suggestion ?
It looks as if your ALIX booted through all stages and successfully
loaded the kernel /bsd, but fails to start this kernel. Maybe check
out http://www.openbsd.org/faq/faq14.html#Boot386 , notably item 4.,
to help with diagnosis and repair.
Are you sure that the kernel /bsd on your CF card is ok? I would try
and replace it temporarily by /bsd from the current snapshot.
Also, I notice that your ALIX is still running BIOS 0.98. My own
experience from today showed that the GENERIC -current stock kernel
will fail at least ltaer on in the process when glxpcib detects the
AMD5536 PCI bridge and tries to start the hardware timer which is then
assigned to the watchdog. Upgrading the BIOS to the latest version
0.99 solved the problem for me just two hours ago, see my three
consecutive posts from earlier today.
Regards,
Rolf
Well, I finally got it booting. As suggested I upgraded the BIOS to
release 0.99 and configured the device to work at 9k6bps.
Now the problem is that it gets stuck just before having the login
prompt, after printing the date and time, any idea ?
Thanks again!
PC Engines ALIX.2 v0.99
640 KB Base Memory
261120 KB Extended Memory
01F0 Master 044A CF CARD 1GB
Phys C/H/S 1966/16/63 Log C/H/S 983/32/63
Using drive 0, partition 3;
Loading;...
probing: pc0 com0 pci mem[640K 255M a20=on]
disk: hd0
>> OpenBSD/i386 BOOT 3.01
boot> set tty com0
switching console to com0
>> OpenBSD/i386 BOOT 3.01
boot>
booting hd0a:/bsd: 5665588+872060 [52+291168+272312]=0x6c5c70
entry point at 0x200120o?=o?=
[ using 563904 bytes of bsd ELF symbol table ]
Copyright (c) 1982, 1986, 1989, 1991, 1993
The Regents of the University of California. All rights reserved.
Copyright (c) 1995-2007 OpenBSD. All rights reserved.
http://www.OpenBSD.org
OpenBSD 4.2 (GENERIC) #375: Tue Aug 28 10:38:44 MDT 2007
[EMAIL PROTECTED]:/usr/src/sys/arch/i386/compile/GENERIC
RTC BIOS diagnostic error 80<clock_battery>
cpu0: Geode(TM) Integrated Processor by AMD PCS ("AuthenticAMD"
586-class) 499 MHz
cpu0: FPU,DE,PSE,TSC,MSR,CX8,SEP,PGE,CMOV,CFLUSH,MMX
real mem = 268009472 (255MB)
avail mem = 251506688 (239MB)
RTC BIOS diagnostic error 80<clock_battery>
mainbus0 at root
bios0 at mainbus0: AT/286+ BIOS, date 12/10/07, BIOS32 rev. 0 @ 0xfceb2
pcibios0 at bios0: rev 2.1 @ 0xf0000/0x10000
pcibios0: pcibios_get_intr_routing - function not supported
pcibios0: PCI IRQ Routing information unavailable.
pcibios0: PCI bus #0 is the last bus
bios0: ROM list: 0xe0000/0xa800
cpu0 at mainbus0
pci0 at mainbus0 bus 0: configuration mode 1 (bios)
pchb0 at pci0 dev 1 function 0 "AMD Geode LX" rev 0x31
glxsb0 at pci0 dev 1 function 2 "AMD Geode LX Crypto" rev 0x00: RNG AES
vr0 at pci0 dev 9 function 0 "VIA VT6105M RhineIII" rev 0x96: irq 10,
address 00:0d:b9:12:d5:4c
ukphy0 at vr0 phy 1: Generic IEEE 802.3u media interface, rev. 3: OUI
0x004063, model 0x0034
vr1 at pci0 dev 11 function 0 "VIA VT6105M RhineIII" rev 0x96: irq 12,
address 00:0d:b9:12:d5:4d
ukphy1 at vr1 phy 1: Generic IEEE 802.3u media interface, rev. 3: OUI
0x004063, model 0x0034
ath0 at pci0 dev 12 function 0 "Atheros AR5212" rev 0x01: irq 9
ath0: AR5213 5.9 phy 4.3 rf5112a 3.6, FCC2A*, address 00:0b:6b:85:20:5f
pcib0 at pci0 dev 15 function 0 "AMD CS5536 ISA" rev 0x03
pciide0 at pci0 dev 15 function 2 "AMD CS5536 IDE" rev 0x01: DMA,
channel 0 wired to compatibility, channel 1 wired to compatibility
wd0 at pciide0 channel 0 drive 0: <CF CARD 1GB>
wd0: 1-sector PIO, LBA, 967MB, 1981728 sectors
wd0(pciide0:0:0): using PIO mode 4, DMA mode 2
pciide0: channel 1 ignored (disabled)
ohci0 at pci0 dev 15 function 4 "AMD CS5536 USB" rev 0x02: irq 15,
version 1.0, legacy support
ehci0 at pci0 dev 15 function 5 "AMD CS5536 USB" rev 0x02: irq 15
usb0 at ehci0: USB revision 2.0
uhub0 at usb0: AMD EHCI root hub, rev 2.00/1.00, addr 1
isa0 at pcib0
isadma0 at isa0
pcppi0 at isa0 port 0x61
midi0 at pcppi0: <PC speaker>
spkr0 at pcppi0
npx0 at isa0 port 0xf0/16: reported by CPUID; using exception 16
pccom0 at isa0 port 0x3f8/8 irq 4: ns16550a, 16 byte fifo
pccom0: console
usb1 at ohci0: USB revision 1.0
uhub1 at usb1: AMD OHCI root hub, rev 1.00/1.00, addr 1
biomask e9ef netmask ffef ttymask ffef
pctr: user-level cycle counter enabled
mtrr: K6-family MTRR support (2 registers)
nvram: invalid checksum
dkcsum: wd0 matches BIOS drive 0x80
root on wd0a swap on wd0b dump on wd0b
WARNING: / was not properly unmounted
clock: unknown CMOS layout
WARNING: clock time much less than file system time
WARNING: using file system time
WARNING: CHECK AND RESET THE DATE!
Automatic boot in progress: starting file system checks.
/dev/rwd0a: 2238 files, 15388 used, 35099 free (243 frags, 4357 blocks,
0.5% fragmentation)
/dev/rwd0a: MARKING FILE SYSTEM CLEAN
/dev/rwd0d: 17 files, 1750 used, 48569 free (17 frags, 6069 blocks, 0.0%
fragmentation)
/dev/rwd0d: MARKING FILE SYSTEM CLEAN
/dev/rwd0e: 1 files, 1 used, 50318 free (14 frags, 6288 blocks, 0.0%
fragmentation)
/dev/rwd0e: MARKING FILE SYSTEM CLEAN
/dev/rwd0g: 9806 files, 87032 used, 205911 free (79 frags, 25729 blocks,
0.0% fragmentation)
/dev/rwd0g: MARKING FILE SYSTEM CLEAN
/dev/rwd0f: 996 files, 4985 used, 20110 free (206 frags, 2488 blocks,
0.8% fragmentation)
/dev/rwd0f: MARKING FILE SYSTEM CLEAN
setting tty flags
pf enabled
net.inet.ip.forwarding: 0 -> 1
starting network
no IP address found for xl1:network
/etc/pf.conf:29: could not parse host specification
no IP address found for xl1:network
/etc/pf.conf:31: could not parse host specification
no IP address found for xl1:network
/etc/pf.conf:66: could not parse host specification
no IP address found for xl1:network
/etc/pf.conf:89: could not parse host specification
pfctl: Syntax error in config file: pf rules not loaded
starting system logger
starting initial daemons: ntpd.
savecore: no core dump
checking quotas: done.
building ps databases: kvm dev.
clearing /tmp
starting pre-securelevel daemons:.
setting kernel security level: kern.securelevel: 0 -> 1
creating runtime link editor directory cache.
preserving editor files
starting network daemons: sendmail httpd ftp-proxy sshd.
starting local daemons:.
noip2
postfix/postfix-script: starting the Postfix mail system
dnsmasqdnsmasq: unknown interface xl1
standard daemons: cron.
Sat Jan 12 11:21:47 GMT+2 2008
