I'm missing the bootloader interaction with OpenBSD 4.2 installed on a
compact flash card in this alix2c3. With the most recent bios from PC
Engines 0.99. If I strike any keys ( like boot -s) during the time when
the boot> prompt should appear the system will not boot. If I wait it
boots fine. The output from a console session is below. When this same
compact flash is installed in a PC Engines wrap board I get the boot>
prompt.
PC Engines ALIX.2 v0.99
640 KB Base Memory
261120 KB Extended Memory
01F0 Master 044A TRANSCEND
Phys C/H/S 993/16/63 Log C/H/S 993/16/63
Using drive 0, partition 3;
Loading;...
probing: pc0 com0 pci mem[640K 255M a20=on]
disk: hd0
>> OpenBSD/i386 BOOT 3.01
-
com0: 38400 baud
switching console to com0
*** some extended ascii characters I appearently can't paste here ***
[ using 563904 bytes of bsd ELF symbol table ]
Copyright (c) 1982, 1986, 1989, 1991, 1993
The Regents of the University of California. All rights
reserved.
Copyright (c) 1995-2007 OpenBSD. All rights reserved.
http://www.OpenBSD.org
OpenBSD 4.2 (GENERIC) #375: Tue Aug 28 10:38:44 MDT 2007
[EMAIL PROTECTED]:/usr/src/sys/arch/i386/compile/GENERIC
RTC BIOS diagnostic error 80<clock_battery>
cpu0: Geode(TM) Integrated Processor by AMD PCS ("AuthenticAMD"
586-class) 499 MHz
cpu0: FPU,DE,PSE,TSC,MSR,CX8,SEP,PGE,CMOV,CFLUSH,MMX
real mem = 268009472 (255MB)
avail mem = 251506688 (239MB)
RTC BIOS diagnostic error 80<clock_battery>
mainbus0 at root
bios0 at mainbus0: AT/286+ BIOS, date 12/10/07, BIOS32 rev. 0 @ 0xfceb2
pcibios0 at bios0: rev 2.1 @ 0xf0000/0x10000
pcibios0: pcibios_get_intr_routing - function not supported
pcibios0: PCI IRQ Routing information unavailable.
pcibios0: PCI bus #0 is the last bus
bios0: ROM list: 0xe0000/0xa800
cpu0 at mainbus0
pci0 at mainbus0 bus 0: configuration mode 1 (bios)
pchb0 at pci0 dev 1 function 0 "AMD Geode LX" rev 0x31
glxsb0 at pci0 dev 1 function 2 "AMD Geode LX Crypto" rev 0x00: RNG AES
vr0 at pci0 dev 9 function 0 "VIA VT6105M RhineIII" rev 0x96: irq 10,
address 00:0d:b9:12:6e:e4
ukphy0 at vr0 phy 1: Generic IEEE 802.3u media interface, rev. 3: OUI
0x004063, model 0x0034
vr1 at pci0 dev 10 function 0 "VIA VT6105M RhineIII" rev 0x96: irq 11,
address 00:0d:b9:12:6e:e5
ukphy1 at vr1 phy 1: Generic IEEE 802.3u media interface, rev. 3: OUI
0x004063, model 0x0034
vr2 at pci0 dev 11 function 0 "VIA VT6105M RhineIII" rev 0x96: irq 12,
address 00:0d:b9:12:6e:e6
ukphy2 at vr2 phy 1: Generic IEEE 802.3u media interface, rev. 3: OUI
0x004063, model 0x0034
pcib0 at pci0 dev 15 function 0 "AMD CS5536 ISA" rev 0x03
pciide0 at pci0 dev 15 function 2 "AMD CS5536 IDE" rev 0x01: DMA,
channel 0 wired to compatibility, channel 1 wired to compatibility
wd0 at pciide0 channel 0 drive 0: <TRANSCEND>
wd0: 1-sector PIO, LBA, 488MB, 1000944 sectors
wd0(pciide0:0:0): using PIO mode 4
pciide0: channel 1 ignored (disabled)
ohci0 at pci0 dev 15 function 4 "AMD CS5536 USB" rev 0x02: irq 15,
version 1.0, legacy support
ehci0 at pci0 dev 15 function 5 "AMD CS5536 USB" rev 0x02: irq 15
usb0 at ehci0: USB revision 2.0
uhub0 at usb0: AMD EHCI root hub, rev 2.00/1.00, addr 1
isa0 at pcib0
isadma0 at isa0
pcppi0 at isa0 port 0x61
midi0 at pcppi0: <PC speaker>
spkr0 at pcppi0
npx0 at isa0 port 0xf0/16: reported by CPUID; using exception 16
pccom0 at isa0 port 0x3f8/8 irq 4: ns16550a, 16 byte fifo
pccom0: console
usb1 at ohci0: USB revision 1.0
uhub1 at usb1: AMD OHCI root hub, rev 1.00/1.00, addr 1
biomask e3ef netmask ffef ttymask ffef
pctr: user-level cycle counter enabled
mtrr: K6-family MTRR support (2 registers)
nvram: invalid checksum
dkcsum: wd0 matches BIOS drive 0x80
root on wd0a swap on wd0b dump on wd0b
clock: unknown CMOS layout
WARNING: clock time much less than file system time
WARNING: using file system time
WARNING: CHECK AND RESET THE DATE!
Automatic boot in progress: starting file system checks.
/dev/rwd0a: file system is clean; not checking
/dev/rwd0e: file system is clean; not checking
/dev/rwd0d: file system is clean; not checking
pax: /var/./cron/tabs/.sock skipped. Sockets cannot be copied or
extracted
pax: /var/./empty/dev/log skipped. Sockets cannot be copied or extracted
mount_mfs: reduced number of fragments per cylinder group from 368 to
352 to enlarge last cylinder group
setting tty flags
pf enabled
starting network
starting system logger
starting initial daemons: ntpd.
savecore: no core dump
checking quotas: done.
building ps databases: kvm dev.
clearing /tmp
starting pre-securelevel daemons:.
setting kernel security level: kern.securelevel: 0 -> 1
creating runtime link editor directory cache.
preserving editor files
starting network daemons: sendmail ftp-proxy inetd sshd.
starting local daemons:.
standard daemons: cron.
Wed Jan 2 15:54:41 MST 2008
OpenBSD/i386 (firewall.icdnt.local) (tty00)
login:
