On Fri, 14 Sep 2007 23:37:39 +0700, Sys.Admin <[EMAIL PROTECTED]> wrote:

Thanks Sys Admin,
However, is this mean that I cannot, forever, use the em1 :D ?

Thanks again,
Hello Insan,

Friday, September 14, 2007, 8:55:21 AM, you wrote:

IPS> Dear all,
IPS> I have recently facing a problem when installing openBSD 4.0 on intel IPS> S3000AH, it seems that the embedded gigabit ethernet (em1) is causing IPS> this, since openBSD installer trap a kernel panic message when it tried to IPS> load the module. In some discussion, to troubleshoot this is to change IPS> vparam.h. Since I am no programmer, would anyone be kind enough to help me
IPS> with this.

IPS> dmesg:
IPS> em1 at pci3 dev 0 function 0 "Intel PRO/1000MT (82573e)" rev
IPS> 0x03uvm_fault(0xd0691180, 0x1f000, 0, 1) ->
IPS> fatal page fault (6) in supervisor mode
IPS> trap type 6 code 0 eip d02b0a10 cs 8 eflags 10202 cr2 1ff07 cp0
IPS> panic: trap type 6, code-0, pc-d02b0a10

In S3000 bios only allow the PCIe em0.

Set s3000 em1 (PCI) to 'disconnect'



-





--
Insan Praja SW

Reply via email to