yeah, this is akward...
i guess i should plug my mpi in again.
On 05/04/2007, at 2:50 AM, Thierry Lacoste wrote:
On Wednesday 04 April 2007 17:37, Chris Black wrote:
Thierry Lacoste wrote:
I installed OpenBSD on a Dell PowerEdge with
a raid1 array controlled by a SAS 5iR controller
thanks to the new mpi driver.
mpi0 at pci2 dev 8 function 0 "Symbios Logic SAS1068" rev 0x01:
irq 5
scsibus0 at mpi0: 63 targets
sd0 at scsibus0 targ 0 lun 0: <Dell, VIRTUAL DISK, 1028> SCSI3 0/
direct
fixed sd0: 69618MB, 69618 cyl, 16 head, 128 sec, 512 bytes/sec,
142577664
sec total
I would like to know if there is a way to monitor my array.
Regards,
Thierry.
Have you tried bioctl?
Yes. I use it with ami (4) but here it gives
# bioctl mpi0
bioctl: Can't locate mpi0 device via /dev/bio
The bio 4 manpage dosn't mention mpi0.
Thierry.
