So I used sysupgrade to upgrade the ERL from 6.7 to 6.8. It went through everything fine, downloaded the sets, extracts, etc. and reboots. However, it boots back into the old 6.7 kernel. I can see /bsd.upgrade created, and /home/_sysupgrade is empty. but did not see any option to trigger the upgrade. I thought it should have been automatically handled by sysupgrade.
What did I miss? Thanks. -Amarendra erl# uname -a OpenBSD erl.lan 6.7 GENERIC.MP#134 octeon erl# ls -l total 79128 -rw-r--r-- 1 root wheel 578 May 7 2020 .cshrc -rw-r--r-- 1 root wheel 468 May 7 2020 .profile drwxr-xr-x 2 root wheel 512 May 7 2020 altroot -rw-r--r-- 1 root wheel 160 Mar 31 00:08 auto_upgrade.conf drwxr-xr-x 2 root wheel 1024 May 7 2020 bin -rwx------ 1 root wheel 7626800 Mar 31 00:10 bsd -rwx------ 1 root wheel 7623592 Mar 31 00:01 bsd.booted -rw------- 1 root wheel 8843608 May 7 2020 bsd.rd -rw------- 1 root wheel 7568260 May 7 2020 bsd.sp -rwx------ 1 root wheel 8823044 Mar 31 00:09 bsd.upgrade drwxr-xr-x 4 root wheel 18432 Mar 31 00:10 dev drwxr-xr-x 23 root wheel 2048 Mar 31 00:11 etc drwxr-xr-x 4 root wheel 512 Oct 15 21:09 home drwxr-xr-x 2 root wheel 512 May 7 2020 mnt drwx------ 3 root wheel 512 Mar 31 01:30 root drwxr-xr-x 2 root wheel 1536 May 7 2020 sbin lrwxrwx--- 1 root wheel 11 May 7 2020 sys -> usr/src/sys drwxrwxrwt 6 root wheel 512 Mar 31 07:45 tmp drwxr-xr-x 16 root wheel 512 Sep 7 2020 usr drwxr-xr-x 23 root wheel 512 May 7 2020 var erl# erl# dmesg Copyright (c) 1982, 1986, 1989, 1991, 1993 The Regents of the University of California. All rights reserved. Copyright (c) 1995-2020 OpenBSD. All rights reserved. https://www.OpenBSD.org OpenBSD 6.7 (GENERIC.MP) #134: Thu May 7 16:05:06 MDT 2020 dera...@octeon.openbsd.org:/usr/src/sys/arch/octeon/compile/GENERIC.MP real mem = 536870912 (512MB) avail mem = 506740736 (483MB) mainbus0 at root: board 20002 rev 2.18 cpu0 at mainbus0: CN50xx CPU rev 0.1 500 MHz, Software FP emulation cpu0: cache L1-I 32KB 4 way D 16KB 64 way, L2 128KB 8 way cpu1 at mainbus0: CN50xx CPU rev 0.1 500 MHz, Software FP emulation cpu1: cache L1-I 32KB 4 way D 16KB 64 way, L2 128KB 8 way clock0 at mainbus0: int 5 octcrypto0 at mainbus0 iobus0 at mainbus0 simplebus0 at iobus0: "soc" octciu0 at simplebus0 octsmi0 at simplebus0 octpip0 at simplebus0 octgmx0 at octpip0 interface 0 cnmac0 at octgmx0: RGMII, address 78:8a:20:46:a8:c0 atphy0 at cnmac0 phy 7: AR8035 10/100/1000 PHY, rev. 2 cnmac1 at octgmx0: RGMII, address 78:8a:20:46:a8:c1 atphy1 at cnmac1 phy 6: AR8035 10/100/1000 PHY, rev. 2 cnmac2 at octgmx0: RGMII, address 78:8a:20:46:a8:c2 atphy2 at cnmac2 phy 5: AR8035 10/100/1000 PHY, rev. 2 com0 at simplebus0: ns16550a, 64 byte fifo com0: console dwctwo0 at iobus0 base 0x1180068000000 irq 56 usb0 at dwctwo0: USB revision 2.0 uhub0 at usb0 configuration 1 interface 0 "Octeon DWC2 root hub" rev 2.00/1.00 addr 1 octrng0 at iobus0 base 0x1400000000000 irq 0 /dev/ksyms: Symbol table not valid. umass0 at uhub0 port 1 configuration 1 interface 0 "Lexar USB Flash Drive" rev 2.10/11.00 addr 2 umass0: using SCSI over Bulk-Only scsibus0 at umass0: 2 targets, initiator 0 sd0 at scsibus0 targ 1 lun 0: <Lexar, USB Flash Drive, 1100> removable serial.21c40cd1719080003000 sd0: 30526MB, 512 bytes/sector, 62517248 sectors vscsi0 at root scsibus1 at vscsi0: 256 targets softraid0 at root scsibus2 at softraid0: 256 targets boot device: sd0 root on sd0a (2124441bc835a462.a) swap on sd0b dump on sd0b WARNING: No TOD clock, believing file system. WARNING: CHECK AND RESET THE DATE!
