Hi, I wonder if you’re not using fdisk for an MBR setup and disklabel for GPT.
Why won’t you use 64 as the starting offset of the RAID partition ? -- Envoyé de mon iPhone > Le 22 mars 2019 à 23:26, Normen Wohner <nor...@wohner.eu> a écrit : > > I thought you might be able to help me with a setup concerning > Full Disk Encryption on OpenBSD 6.4 where I am at my whits end. > I am trying to install on a Sony Vaio VPC P11S1E netbook. > It is a 32-bit x86 machine with an internal SSD and SD card reader. > > During boot of the installer my internal disk shows up as wd0. > I have no Idea why it would be IDE but be that as it may. > Plugging in any USB drive shows as sd0 while the SD card-reader > shows two devices, respectively some controller on sd0 and the > actual drive on sd1. > > I really hope to find anything else I could try. > > What I have tried thus far. > booting into the installer, > once everything is in ramdisk is at the Install > etc. prompt I unplug the boot USB and proceed with: > > (S)hell > > > # dd if=/dev/zero of=/dev/wd0 bs=1m count=8 > to erase previous RAID attempt > > # fdisk -iy wd0 > # disklabel -E wd0 >> z >> a a > offset: [64] 1024 > size: [n] > FS type: [4.2BSD] RAID >> w >> q > returns: 'No label changes.' > > # cd /dev > # sh MAKEDEV sd1 > # sh MAKEDEV sd2 > # cd / > > after that either > Route 1: > plugging in SD card > > # fdisk -iy sd1 > # disklabel -E sd1 >> z >> a a > offset: [64] 1024 > size: [n] 1m > FS type: [4.2BSD] RAID >> w >> q > returns: 'No label changes.' > > # dd if=/dev/random of=/dev/sd1a > > # bioctl -c C -k sd1a -l wd0a softraid0 > returns: 'Error sd1 did not quit correctly' > > > This Error remains consistend between boots, > even after restarting to the Installer > > alternatively > Route 2: > plugging in USB stick > # fdisk -iy sd0 > # disklabel -E sd0 >> z >> a a > offset: [64] 1024 > size: [n] 1m > FS type: [4.2BSD] RAID >> w >> q > returns: No label changes. > > # dd if=/dev/random of=/dev/sd0a > > # bioctl -c C -k sd0a -l wd0a softraid0 > returns: softraid0: CRYPTO volume attached as sd2 > #exit > (I)nstall to sd2 > ... > hangs in BIOS after reboot whenever > the Keydrive is plugged in. >
