I thought you might be able to help me with a setup concerning Full Disk Encryption on OpenBSD 6.4 where I am at my whits end. I am trying to install on a Sony Vaio VPC P11S1E netbook. It is a 32-bit x86 machine with an internal SSD and SD card reader.
During boot of the installer my internal disk shows up as wd0. I have no Idea why it would be IDE but be that as it may. Plugging in any USB drive shows as sd0 while the SD card-reader shows two devices, respectively some controller on sd0 and the actual drive on sd1. I really hope to find anything else I could try. What I have tried thus far. booting into the installer, once everything is in ramdisk is at the Install etc. prompt I unplug the boot USB and proceed with: (S)hell # dd if=/dev/zero of=/dev/wd0 bs=1m count=8 to erase previous RAID attempt # fdisk -iy wd0 # disklabel -E wd0 > z > a a offset: [64] 1024 size: [n] FS type: [4.2BSD] RAID > w > q returns: 'No label changes.' # cd /dev # sh MAKEDEV sd1 # sh MAKEDEV sd2 # cd / after that either Route 1: plugging in SD card # fdisk -iy sd1 # disklabel -E sd1 > z > a a offset: [64] 1024 size: [n] 1m FS type: [4.2BSD] RAID > w > q returns: 'No label changes.' # dd if=/dev/random of=/dev/sd1a # bioctl -c C -k sd1a -l wd0a softraid0 returns: 'Error sd1 did not quit correctly' This Error remains consistend between boots, even after restarting to the Installer alternatively Route 2: plugging in USB stick # fdisk -iy sd0 # disklabel -E sd0 > z > a a offset: [64] 1024 size: [n] 1m FS type: [4.2BSD] RAID > w > q returns: No label changes. # dd if=/dev/random of=/dev/sd0a # bioctl -c C -k sd0a -l wd0a softraid0 returns: softraid0: CRYPTO volume attached as sd2 #exit (I)nstall to sd2 ... hangs in BIOS after reboot whenever the Keydrive is plugged in.
