Hi Diana, Ill ask a few engineers I know who use the ubnt gear quite a bit ... and get back to you.. ubnt may have a utility for it ...
On Tue, 12 Feb 2019 at 23:17, Diana Eichert <deich...@wrench.com> wrote: > > I've been running OpenBSD 6.4 on a USG PRO-4 using external SSD drive > in USB enclosure. > > The platform page states "OpenBSD/octeon can be installed on all > machines which have local Compact Flash or USB storage". > > The USG PRO-4 uses emmc storage. According to commit 1.28 of RAMDISK config " > > Add a driver for OCTEON MMC host controller. > > Tested on EdgeRouter Pro, and Shasta." > > Therefore I should be able to install on the emmc, correct assumption? > > If so, is there a good way to dump existing factory firmware from emmc > before I install OpenBSD? At some point I may have to restore to > factory. > > thanks > > diana > -- Kindest regards, Tom Smyth Mobile: +353 87 6193172 The information contained in this E-mail is intended only for the confidential use of the named recipient. If the reader of this message is not the intended recipient or the person responsible for delivering it to the recipient, you are hereby notified that you have received this communication in error and that any review, dissemination or copying of this communication is strictly prohibited. If you have received this in error, please notify the sender immediately by telephone at the number above and erase the message You are requested to carry out your own virus check before opening any attachment.
