Hi, I thought about your problem and as i can't figure out what may be going on, I thought a picture would be worth a thousands words and as my English is not as good as I wish, I did a video instead.
Not sure how many words that would be worth, but what ever, I am sure it would be way better then anything I could possibly write! I have done with it QuickTime only because that's what I had available around right now, hopefully you can watch it. I just do not have any Window$ computer around. Plus I wouldn't want it to crash on me as I was doing the video! (;> Anyway, you have it from the start to the end, including the show of the fdisk, disklabel, as well as the U-Boot env section and what you can do to boot it quickly without making changes to it as well when it is setup to boot. I also load it from scratch and put the files on the FAT partition as well and did a complete install, NOT an upgrade. If that doesn't get you going, I can't say what will. Enjoy and hopefully it will be useful. As for the stall not much I can do there, my flash drive is pretty slow, but still everything from start to finish, wipe, install reboot, etc was 18 minutes or so including my typing mistakes. You can get it here: http://www.openbsdsupport.org/octeon/Octeon-Install.mov And no before you asked that has NOTHING to do with the official project. It's just a very old (11 years and counting) demonstration to show talk on misc@ is cheap and doing is not. Best, Daniel. On 12/12/15 10:42 PM, jungle Boogie wrote: > Hello All, > > Despite the very helpful reply from Daniel on this thread: > http://marc.info/?l=openbsd-misc&m=144937777626054&w=2 > > I'm faced with the same message upon accepting the default partition > and disk layout: > disklabel(19593): syscall 5 "cpath" > Abort trap > > When attempting to use the Octeon snapshot from November: > http://ftp.openbsd.org/pub/OpenBSD/snapshots/octeon/ > > Is there something more I can do to get this working or is this some > pledge issue? To rule out a USB disk problem or edge router lite > problem, I can load the previous bsd.rd file but I would need someone > to share that with me because I don't have it anymore. > > Thanks!
