On 10.04.19 20:04, Paul A. Rubin wrote:
On 4/10/19 2:56 AM, Wolfgang Engelmann wrote:
What do I have to do if eps figures are not shown in the pdf file? I
had before never problems with it.
Wolfgang
Things you can try:
1. After compiling the document to PDF, check Document > LaTeX log
for any error messages. (You can search for "eps" to help find the
relevant sections of the log.)
2. While the document is open in LyX (and after compiling), locate
the temporary directory in which LyX is working and see if (a) the
.eps files have been copied there and (b) if .pdf versions have
been created.
3. Run LyX from a terminal with "lyx -dbg graphics". A verbose log of
what is going on will appear in the terminal window. Open the
document and make note of the point in the log at which loading is
done. (Anything helpful will occur after this point.) Compile to
PDF and see if any subsequent output in the log identifies a
problem with graphics conversion.
Paul
Thanks a lot, Paul. However, lyx -dbg graphics command was not found
(3). I installed it.
lyx-dbg ist schon die neueste Version (2.3.2-1~xenial~ppa1). Starting my
lyx with it tells me the command was not found:
wolfgang@wolfgang-Mr-Whisper-Ultra-SSD-II:/mnt/sdb/we/Publikationen-eigene-20170530/PBR-4thEdition$
lyx-dbg graphics PBR-4thEdition-20170411.lyx
lyx-dbg: command not found
texhash does not help
Starting lyx from a terminal tells me
Error while exporting format: LaTeX (pdflatex)File
'/tmp/lyx_tmpdir.DOvyEMq14243/lyx_tmpbuf0/PBR-4thEdition-20170410-A.tex'
was not closed properly
Note that this is what I asked in a separate mail to the list: Re: What
to do with this error: File '/tmp/lyx_tmpdir
to which Kornel (thanks!) answered
It is a temporary directory, each time will be different. Renaming does not
change anything.
It is valid only for_one_ session.
Kornel
Starting lyx from a terminal tells me
Error while exporting format: LaTeX (pdflatex)File
'/tmp/lyx_tmpdir.DOvyEMq14243/lyx_tmpbuf0/PBR-4thEdition-20170410-A.tex'
was not closed properly
Usually I got the possibility to check the log and/or see the pdf output
anyway. Not now, unfortunately.
What I will do is to start with a minimal file (the original one is a
few year old and worked fine) and complete it slowly.
Would be good to know why the lyx-dbg is not working, even after
reconfigure.
Thanks, Wolfgang
