On Mon, Jun 2, 2008 at 10:25 PM, Bennett Helm <[EMAIL PROTECTED]> wrote:
> On Mon, Jun 2, 2008 at 5:02 PM, Konrad Hofbauer <[EMAIL PROTECTED]> > wrote: > >> Bennett, Anders, >> >> please find at >> <http://www2.spsc.tugraz.at/people/hofbauer/lyx/LyX-Mac-1.6.0beta2.zip> >> a universal binary built on Mac OS X 10.4.11 from lyx-1.6.0beta2.tar.gz, >> and using the attached script. >> >> ### THIS IS NOT AN OFFICIAL RELEASE ### >> >> I only did very little testing, it produces output, but fails with a >> Latex-error on the UserGuide. > > > Works for me on Intel-10.5.3. > > >> Bennett: If the OK from Jose for beta2 comes, you can add everything else >> needed, and ship it. Also, with the attached script and the patch that I >> sent beforehand (and which was for consistency not used for this build ), >> would you try compiling on 10.5 again and see if it works on 10.4 then? >> (with all my -isysroot stuff). > > > What we need is to place the LyX-installer (an X-Code project) in lyx-devel > > development > MacOSX > installation (or some such) so that we're not > dependent on me. This installer should in any case be looked at and cleaned > up by someone who knows what they're doing. Better yet, we should eliminate > the installer entirely.... > > If I post the installer to my server, would someone add it to LyX sources? > > P.S. I copied the attached script section by section into Terminal. When >> executing or source'ing the script, for some reason configure reported some >> errors. > > > Seemed to work for me. The patch seemed to work well also. I've > cross-compiled for Intel and PPC, and tested both on Macs with 10.5.3 > installed. I can check tomorrow to see if PPC-10.4 works. > I can now confirm that it also works on PPC-10.4. Has anyone looked at Konrad's patch -- needed for cross-compilation on Mac? Bennett
