On Mon, Jun 2, 2008 at 5:02 PM, Konrad Hofbauer <[EMAIL PROTECTED]> wrote:
> Bennett, Anders, > > please find at > <http://www2.spsc.tugraz.at/people/hofbauer/lyx/LyX-Mac-1.6.0beta2.zip> > a universal binary built on Mac OS X 10.4.11 from lyx-1.6.0beta2.tar.gz, > and using the attached script. > > ### THIS IS NOT AN OFFICIAL RELEASE ### > > I only did very little testing, it produces output, but fails with a > Latex-error on the UserGuide. Works for me on Intel-10.5.3. > Bennett: If the OK from Jose for beta2 comes, you can add everything else > needed, and ship it. Also, with the attached script and the patch that I > sent beforehand (and which was for consistency not used for this build ), > would you try compiling on 10.5 again and see if it works on 10.4 then? > (with all my -isysroot stuff). What we need is to place the LyX-installer (an X-Code project) in lyx-devel > development > MacOSX > installation (or some such) so that we're not dependent on me. This installer should in any case be looked at and cleaned up by someone who knows what they're doing. Better yet, we should eliminate the installer entirely.... If I post the installer to my server, would someone add it to LyX sources? P.S. I copied the attached script section by section into Terminal. When > executing or source'ing the script, for some reason configure reported some > errors. Seemed to work for me. The patch seemed to work well also. I've cross-compiled for Intel and PPC, and tested both on Macs with 10.5.3 installed. I can check tomorrow to see if PPC-10.4 works. Bennett
