Hi Guys,
I think this is more of a latex question than a lyx question but I don't know
who to turn to.
Running standard RH6 release of tetex (tetex-0.9-17). Lyx1.0.3-5. Getting
extremely stupid hyphens appearing with only a single letter left or right of
the hyphen (eg constrain-t). Please see attached (very short) lyx file.
I haven't seen this before!
Looked through the tex archives and shouldn't be having any troubles with the
version I'm running:
tex -version
TeX (Web2C 7.3) 3.14159
kpathsea version 3.3
Have tried resetting the hyphen length using
\renewcommand{\lefthyphenmin}{3}
\renewcommand{\righthyphenmin}{3}
to no avail.
Only way I've been able to over come this is by using \hyphenation
(eg \hyphenation{constraint}).
Has anybody seen this before?
Ben
--
_________________________________________
Ben Cazzolato
Fluid Dynamics and Acoustics Group
Institute of Sound and Vibration Research
University of Southampton,
Southampton, SO17 1BJ
UK
Email: [EMAIL PROTECTED], or
[EMAIL PROTECTED], or
[EMAIL PROTECTED], or
Work: +44 (0)1703 594 967
Fax: +44 (0)1703 593 190
Mobile: +44 (0)790 163 8826
Web Page : http://www.soton.ac.uk/~bscazz/
_________________________________________
#This file was created by <bscazz> Sun Aug 22 12:31:53 1999
#LyX 1.0 (C) 1995-1999 Matthias Ettrich and the LyX Team
\lyxformat 2.15
\textclass article
\begin_preamble
% This is to force the hyphens to have at least 3 characters
% either side of the hyphen
%\renewcommand{\lefthyphenmin}{3}
%\renewcommand{\righthyphenmin}{3}
% This is to directly force some words not to be hyphenated
%\hyphenation{constraint}
\end_preamble
\language default
\inputencoding default
\fontscheme times
\graphics default
\float_placement htbp
\paperfontsize 12
\spacing single
\papersize a4paper
\paperpackage a4
\use_geometry 1
\use_amsmath 1
\paperorientation portrait
\leftmargin 25mm
\topmargin 25mm
\rightmargin 25mm
\bottommargin 25mm
\secnumdepth 4
\tocdepth 3
\paragraph_separation indent
\defskip medskip
\quotes_language english
\quotes_times 2
\papercolumns 1
\papersides 1
\paperpagestyle fancy
\layout Subsection
Arbitrary Nodes
\layout Standard
The previous technique of using co-located nodes suffers from the difficulty
that every time the sensor is moved to a new location, the FE model needs
to be re-meshed.
A simpler approach is to estimate the pressure and pressure gradient at
a particular location using four closely located existing points within
the FE mesh, a process that automatically defines the
\begin_inset Quotes eld
\end_inset
sensor
\begin_inset Quotes erd
\end_inset
configuration as well.
The following approach is only suitable when the non-dimensional microphone
spacing is small, ie when
\begin_inset Formula \( 2kh<1 \)
\end_inset
or
\begin_inset Formula \( 2h<\lambda /2\pi \)
\end_inset
.
This is approximately the same constraint for modal analysis of FE models,
namely that there be at least 6 elements per wavelength.
Therefore, the following approach is suitable within the frequency bandwidth
defined by the FE modal model.
\the_end
