Re: Boot problems after adding 2 new disks

Sat, 16 Feb 2019 07:13:45 -0800


On 16/2/19 4:08 pm, Craig Sanders via luv-main wrote:
On Sat, Feb 16, 2019 at 03:00:08PM +1100, Morrie Wyatt wrote:

The one extra step you might need to add to the end of Craig's list would be
to force a rebuild of your bootloader configuration (probably Grub) so that
the fstab UUID / LABEL changes get propagated into grub's config files.

It certainly can't hurt to do that but it shouldn't be necessary.  Grub uses
UUIDs by default unless you tell it not to. There's a commented out option in
/etc/default/grub on debian/ubuntu systems to disable use grub's of UUID:

    # Uncomment if you don't want GRUB to pass "root=UUID=xxx" parameter to Linux
    #GRUB_DISABLE_LINUX_UUID=true

There's almost no reason why anyone would need to uncomment that.



It might, however, be worthwhile running 'grub-install' on ALL of the drives
*after* the system has successfully booted with the new drives installed.
That way the grub first stage boot loader will be available no matter which
drive the BIOS tries to boot from (this is assuming that it's an old-style
BIOS boot, rather than UEFI. UEFI is different, it loads grub directly from a
smallish FAT-32 EFI partition).

craig

--
craig sanders <[email protected]>
_______________________________________________
luv-main mailing list
[email protected]
https://lists.luv.asn.au/cgi-bin/mailman/listinfo/luv-main

Hi Craig et al,

It is a uefi boot.

Thanks Andrew

_______________________________________________
luv-main mailing list
[email protected]
https://lists.luv.asn.au/cgi-bin/mailman/listinfo/luv-main

Reply via email to