Previous commit 46723bfa540... introduced a new config option
HAVE_BOOTMEM_INFO_NODE that ended up breaking memory hot-remove for ppc
when sparse vmemmap is not defined.
This patch defines HAVE_BOOTMEM_INFO_NODE for ppc and adds the call to
register_page_bootmem_info_node. Without this we get a BUG_ON for memory
hot remove in put_page_bootmem().
This also adds a stub for register_page_bootmem_memmap to allow ppc to build
with sparse vmemmap defined. Leaving this as a stub is fine since the same
vmemmap addresses are also handled in vmemmap_populate and as such are
properly mapped.
Signed-off-by: Nathan Fontenot <nf...@linux.vnet.ibm.com>
---
arch/powerpc/mm/init_64.c | 4 ++++
arch/powerpc/mm/mem.c | 9 +++++++++
mm/Kconfig | 2 +-
3 files changed, 14 insertions(+), 1 deletion(-)
Index: powerpc/arch/powerpc/mm/init_64.c
===================================================================
--- powerpc.orig/arch/powerpc/mm/init_64.c
+++ powerpc/arch/powerpc/mm/init_64.c
@@ -300,5 +300,9 @@ void vmemmap_free(unsigned long start, u
{
}
+void register_page_bootmem_memmap(unsigned long section_nr,
+ struct page *start_page, unsigned long size)
+{
+}
#endif /* CONFIG_SPARSEMEM_VMEMMAP */
Index: powerpc/arch/powerpc/mm/mem.c
===================================================================
--- powerpc.orig/arch/powerpc/mm/mem.c
+++ powerpc/arch/powerpc/mm/mem.c
@@ -297,12 +297,21 @@ void __init paging_init(void)
}
#endif /* ! CONFIG_NEED_MULTIPLE_NODES */
+static void __init register_page_bootmem_info(void)
+{
+ int i;
+
+ for_each_online_node(i)
+ register_page_bootmem_info_node(NODE_DATA(i));
+}
+
void __init mem_init(void)
{
#ifdef CONFIG_SWIOTLB
swiotlb_init(0);
#endif
+ register_page_bootmem_info();
high_memory = (void *) __va(max_low_pfn * PAGE_SIZE);
set_max_mapnr(max_pfn);
free_all_bootmem();
Index: powerpc/mm/Kconfig
===================================================================
--- powerpc.orig/mm/Kconfig
+++ powerpc/mm/Kconfig
@@ -183,7 +183,7 @@ config MEMORY_HOTPLUG_SPARSE
config MEMORY_HOTREMOVE
bool "Allow for memory hot remove"
select MEMORY_ISOLATION
- select HAVE_BOOTMEM_INFO_NODE if X86_64
+ select HAVE_BOOTMEM_INFO_NODE if (X86_64 || PPC64)
depends on MEMORY_HOTPLUG && ARCH_ENABLE_MEMORY_HOTREMOVE
depends on MIGRATION
_______________________________________________
Linuxppc-dev mailing list
Linuxppc-dev@lists.ozlabs.org
https://lists.ozlabs.org/listinfo/linuxppc-dev
