Vineeth wrote:
> Thanks for the reply.
>
> We were referring kuroboxHG.dts which uses Sandpoint architecture; which is
> almost same as ours.
>
> 1. one doubt in kuroboxHG is the ranges property in SOC node says EUMB is at
> 0xFC00_0000; and as per the datasheet of mpc107, the open pic address will
And for powerpc looks u-boot should initialize MPC107 and EUMB_ADDR should be
configured as well. And kernel doesn't reconfigure EUMB again. This is different
from original ppc implementation.
So I think you should check how u-boot did. Note not all targets use 0xfc000000
as EUMB_ADDR. At least for linkstation 0x8000000 is set as EUMB_ADDR. And so
maybe this value, 0xFC000000, should be one typo since kernel don't use this
node property as I previously said.
> be EUMB_BASE + 0x40000; but in kurobox its given as 0x80040000;
>
> 2. We know that our UART is mapped at address 0xDB00_0100; which is
> connected in a PCI-LOCAL bridge whose base is at 0xDB00_0000
> How can i represent these things in dts ? Can the RANGES property of PCI
> node can mention this ?
How do u-boot resided on your target set EUMB_ADDR? Then you can migrate
kuroboxHG.dts with this base address.
Tiejun
>
>
>
>
>
>
>
> On Tue, Aug 2, 2011 at 1:15 PM, tiejun.chen <tiejun.c...@windriver.com>wrote:
>
>> Vineeth wrote:
>>> Hi,
>>>
>>> We are trying to port linux 2.6.38 on MPC7410 based board (This is a
>>> preparatory design by our customer)
>>>
>>> System architecture is as follows,
>>>
>>> MPC7410 <=> MPC107 <=> PCI_to_LOCAL(plx9052) <=> UART
>> MPCXXX should be compatible with TSIXXX. So you can refer to mpc7448_hpc2.
>>
>>> Previously we were using ppc architecture and we had some issues with
>>> page_init() functions; which may be because of our configuration.As we
>> didnt
>>> get much support on ppc architecture we moved to powerpc.
>>>
>>> Now we moved to powerpc architecture. We have some doubts on writing the
>> dts
>>> file. Please find the dts file attached.
>>>
>>> when we checked the legacy_serial.c file, we found that
>>> legacy_serial_parents not expecting a pci-local or a pci bridge as
>> parent.
>>> is our understanding correct ? should we introduce a new pci parent in
>> that
>>> structure ?
>> So you can understand this after refer to the file,
>> arch/powerpc/boot/dts/mpc7448hpc2.dts.
>>
>> Tiejun
>>
>>> We are confused about writing the ranges property of PCI node.we were
>>> referring booting_without_of doc but didnt get much info. Is there any
>> file
>>> which gives better idea about the ranges property ?
>>>
>>> Thanks
>>> Vineeth
>>
>
_______________________________________________
Linuxppc-dev mailing list
Linuxppc-dev@lists.ozlabs.org
https://lists.ozlabs.org/listinfo/linuxppc-dev
