Kumar, Are you planning to release support for dual-port SRIO controller? If yes, it may be just merged into it (unless dual-port implementation already has it).
Alex. > -----Original Message----- > From: linuxppc-dev-bounces+alexandre.bounine=idt....@lists.ozlabs.org > [mailto:linuxppc-dev- > bounces+alexandre.bounine=idt....@lists.ozlabs.org] On Behalf Of Kumar > Gala > Sent: Friday, May 20, 2011 12:29 AM > To: Bounine, Alexandre > Cc: Li Yang-R58472; Xie Shaohui-B21989; Zang Roy-R61911; akpm@linux- > foundation.org; linuxppc-dev@lists.ozlabs.org; Gala Kumar-B11780 > Subject: Re: [PATCH 2/2][v3] rapidio,powerpc/85xx: Error interrupt > handler for sRIO. > > Alex, > > What are we doing with this patch? > > - k > > On Dec 3, 2010, at 12:04 PM, Bounine, Alexandre wrote: > > > I think they should follow the previous two that are in Kumar's tree. > > Probably Kumar may give you a better timeline estimate for this. > > > > Alex. > > > > From: linuxppc-dev-bounces+alexandre.bounine=idt....@lists.ozlabs.org > [mailto:linuxppc-dev- > bounces+alexandre.bounine=idt....@lists.ozlabs.org] On Behalf Of Xie > Shaohui-B21989 > > Sent: Thursday, December 02, 2010 10:29 PM > > To: Bounine, Alexandre; linuxppc-dev@lists.ozlabs.org > > Cc: a...@linux-foundation.org; Gala Kumar-B11780; Li Yang-R58472; > Zang Roy-R61911 > > Subject: RE: [PATCH 2/2][v3] rapidio,powerpc/85xx: Error interrupt > handler for sRIO. > > > > Hi Alex, > > > > May I ask when would these patches be applied to mainline? > > > > > > Best Regards, > > Shaohui Xie > > > > From: Bounine, Alexandre [mailto:alexandre.boun...@idt.com] > > Sent: Wednesday, December 01, 2010 4:49 AM > > To: Xie Shaohui-B21989; linuxppc-dev@lists.ozlabs.org > > Cc: a...@linux-foundation.org; Li Yang-R58472; Gala Kumar-B11780; > Zang Roy-R61911 > > Subject: RE: [PATCH 2/2][v3] rapidio, powerpc/85xx: Error interrupt > handler for sRIO. > > > > Applies correctly now. Lab tested on 8548/RIO setup. > > > > Alex. > > > >> -----Original Message----- > >> From: Shaohui Xie [mailto:b21...@freescale.com] > >> Sent: Thursday, November 18, 2010 1:58 AM > >> To: linuxppc-dev@lists.ozlabs.org > >> Cc: a...@linux-foundation.org; Shaohui Xie; Li Yang; Kumar Gala; Roy > > Zang; Bounine, Alexandre > >> Subject: [PATCH 2/2][v3] rapidio, powerpc/85xx: Error interrupt > > handler for sRIO. > >> > >> The sRIO controller reports errors to the core with one signal, it > > uses > >> register EPWISR to provides the core quick access to where the error > > occurred. > >> The EPWISR indicates that there are 4 interrupts sources, port1, > > port2, message > >> unit and port write receive, but the sRIO driver does not support > > port2 > >> for now, still the handler takes care of port2. > >> Currently the handler only clear error status without any recovery. > > > > _______________________________________________ > > Linuxppc-dev mailing list > > Linuxppc-dev@lists.ozlabs.org > > https://lists.ozlabs.org/listinfo/linuxppc-dev > > _______________________________________________ > Linuxppc-dev mailing list > Linuxppc-dev@lists.ozlabs.org > https://lists.ozlabs.org/listinfo/linuxppc-dev _______________________________________________ Linuxppc-dev mailing list Linuxppc-dev@lists.ozlabs.org https://lists.ozlabs.org/listinfo/linuxppc-dev