Hello list,
I have a P2020 processor on a custom board which uses the embedded
fsl-esdhc controller. Hardware-wise this is functional and in u-boot
everything seems to behave (mmc part 0 gives the correct partition table
and ext2ls/fatls are capable of reading the contents of the sd card).
However as soon as I start Linux (2.6.36), I get all sorts of unwanted
behavior. Linux is unable to detect the partition layout (but if I do a
hexdump of the MBR, I see the endianness is swapped (last 4 bytes are aa
55 00 00). Also when I try to obtain the card registers they show the
same behavior:
# cat ./devices/soc.0/ff72e000.sdhci/mmc_host/mmc0/mmc0:0001/scr
0000b50200000000
While for comparison the same value on my (x86) laptop gives:
edb@lapedb:/sys/devices/pci0000:00/0000:00:1e.0/0000:15:00.2/mmc_host/mmc0/mmc0:0001$
cat scr
02b5000000000000
In my config I have the following set:
CONFIG_MMC_SDHCI=y
CONFIG_MMC_SDHCI_IO_ACCESSORS=y
CONFIG_MMC_SDHCI_BIG_ENDIAN_32BIT_BYTE_SWAPPER=y
# CONFIG_MMC_SDHCI_PCI is not set
CONFIG_MMC_SDHCI_OF=y
CONFIG_MMC_SDHCI_OF_ESDHC=y
any pointers are welcome.
gr
E.
--
Elie De Brauwer
_______________________________________________
Linuxppc-dev mailing list
Linuxppc-dev@lists.ozlabs.org
https://lists.ozlabs.org/listinfo/linuxppc-dev
