On Tue, Aug 18, 2009 at 08:24:17PM -0500, Kumar Gala wrote: > > On Aug 18, 2009, at 6:38 PM, Anton Vorontsov wrote: > > >This patch simply adds sdhci node to the device tree. > > > >We specify clock-frequency manually, so that eSDHC will work without > >upgrading U-Boot. Though, that'll only work for default setup (1500 > >MHz) on new board revisions. For non-default setups, it's recommended > >to upgrade U-Boot, since it will fixup clock-frequency automatically. > > > >Signed-off-by: Anton Vorontsov <avoront...@ru.mvista.com> > > out of interest the 85xx eSDHC don't need the sdhci,wp-inverted > property?
Yes, eSDHC controllers in MPC85xx report normal state in its registers. But the funny thing is that the switch itself is inverted, so to enable writing, on MPC8569E-MDS and MPC8536DS boards we have to place card's write protect tab into "lock" position. Unfortunately we can't fix that in software since controller doesn't permit write operations if it detects write-protected state. On the bright side, IIRC MPC8536DS revision history says that WP line level is fixed via BCSR upgrade. Not sure if it is possible to fix it for MPC8569E-MDS. -- Anton Vorontsov email: cbouatmai...@gmail.com irc://irc.freenode.net/bd2 _______________________________________________ Linuxppc-dev mailing list Linuxppc-dev@lists.ozlabs.org https://lists.ozlabs.org/listinfo/linuxppc-dev
