On Nov 13, 2008, at 9:18 AM, Michael Barkowski wrote:
ethernet0 (called FSL UEC0 in U-Boot) should be enet1 (UCC3/eth1), and ethernet1 should be enet0 (UCC2/eth0), to be consistent with U-Boot so that the interfaces do not swap addresses when control passes from U-Boot to the kernel. Signed-off-by: Michael Barkowski <[EMAIL PROTECTED]> Acked-by: Kim Phillips <[EMAIL PROTECTED]> --- Cheat sheet: | *Nickname* | WAN port | LAN switch | | *MAC address* | ethaddr | eth1addr | | *U-Boot name* | FSL UEC0 | FSL UEC1 | | *Linux name* | eth1 | eth0 | | *Phy ID* | 4 | 0 | | *QE Device* | [EMAIL PROTECTED] | [EMAIL PROTECTED] | arch/powerpc/boot/dts/mpc832x_rdb.dts | 4 ++-- 1 files changed, 2 insertions(+), 2 deletions(-)
applied to merge. - k _______________________________________________ Linuxppc-dev mailing list Linuxppc-dev@ozlabs.org https://ozlabs.org/mailman/listinfo/linuxppc-dev
