David Gibson wrote:
On Thu, Nov 13, 2008 at 10:18:28AM -0500, Michael Barkowski wrote:
ethernet0 (called FSL UEC0 in U-Boot) should be enet1 (UCC3/eth1), and
ethernet1 should be enet0 (UCC2/eth0), to be consistent with U-Boot so
that the interfaces do not swap addresses when control passes from
U-Boot to the kernel.
Um.. why is just swapping the aliases, rather than the enet labels the
right approach here?
Kim suggested it was better to localize the port ordering as a property of the
board rather than that of the QE, and I agreed.
--
Michael
_______________________________________________
Linuxppc-dev mailing list
Linuxppc-dev@ozlabs.org
https://ozlabs.org/mailman/listinfo/linuxppc-dev
