Now back to the first an bigger problem :
currently, I have an "old" U-boot and I have written myself a dts
file.
Problem is : ethernet does not work, but that's not a mac-address
problem,
but something else that I do not understand yet. The symptom is I get
ip route add default via 192.168.85.33 dev eth0
RTNETLINK answers: Network is unreachable
I surmise this is because my eth0 does not become up, and I surmise
again this is because there is no driver selected to drive the phy.
In my arch/ppc setup this was automagically handled by [EMAIL PROTECTED]:1
IIRC
Is there something I can put in my dts file to activate a driver for
my phy ?
Best regards
This slipped under my radar, and I'm only just now finding it again.
Have your issues been resolved? If not, could you send a bit more of
the boot log? There should be a little more if the PHY was not
found. If you were operating with a fixed PHY setup before, then the
generic PHY driver (which will automatically bind to your PHY) should
suffice unless your MDIO bus is broken.
Andy
_______________________________________________
Linuxppc-dev mailing list
Linuxppc-dev@ozlabs.org
https://ozlabs.org/mailman/listinfo/linuxppc-dev
