On Monday 14 January 2008, Sean MacLennan wrote: > Josh Boyer wrote: > > But did you go back and verify the EBC settings were correct on your > > board? This shouldn't be needed at all if the EBC bank settings and > > timings are correct. > > > > josh > > In the EBC0_CFG register we set the RTC (Ready Timeout Count) to 0 and > the sequoia uses 7. Also we set the EMS (External Master Size) to none > and the sequoia sets it to 8 bit. > > This is in uboot, the dts are basically the same.
And the EBC0_BxCR & EBC0BxAP registers for the CS where the NAND is connected? How are they configured? Best regards, Stefan ===================================================================== DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-0 Fax: +49-8142-66989-80 Email: [EMAIL PROTECTED] ===================================================================== _______________________________________________ Linuxppc-dev mailing list Linuxppc-dev@ozlabs.org https://ozlabs.org/mailman/listinfo/linuxppc-dev
