On Wed, 08 Aug 2007 13:45:10 -0500 Jerone Young wrote: > Using the Sequoia (AMCC 440EPx) patches recently submitted to the > list I am unable to boot to fully boot a uImage built with these > patches under Uboot. It appears to hang in very early boot. > > > Here is the output: > => tftp 400000 > sequoia/uImage ENET Speed is 100 Mbps - FULL duplex connection > (EMAC0) Using ppc_4xx_eth0 > device TFTP from server 9.53.41.24; our IP address is > 9.53.41.38 Filename > 'sequoia/uImage'. Load address: > 0x400000 Loading: > ################################################################# > ################################################################# > ################################################################# > ####################### > done Bytes transferred = 1112434 (10f972 > hex) => bootm > 400000 ## Booting image at > 00400000 ... Image Name: > Linux-2.6.23-rc2 Image Type: PowerPC Linux Kernel Image (gzip > compressed) Data Size: 1112370 Bytes = 1.1 > MB Load Address: > 00000000 Entry Point: > 00000000 Verifying Checksum ... > OK Uncompressing Kernel Image ... OK > > _______________________________________________ > Linuxppc-dev mailing list > Linuxppc-dev@ozlabs.org > https://ozlabs.org/mailman/listinfo/linuxppc-dev
This seems to be a wrong image.. Are you using "make zImage" ? The proper uImage after that command would be smth like cuImage* then... -- Sincerely, Vitaly _______________________________________________ Linuxppc-dev mailing list Linuxppc-dev@ozlabs.org https://ozlabs.org/mailman/listinfo/linuxppc-dev
