Nope definitely using a uImage. I'll try a fresh source and try again .. I did base it on kernel.org git tree so I'll try instead with 2.6.23-rc2 and see what happens.
n Thu, 2007-08-09 at 16:56 +0400, Vitaly Bordug wrote: > On Wed, 08 Aug 2007 13:45:10 -0500 > Jerone Young wrote: > > > Using the Sequoia (AMCC 440EPx) patches recently submitted to the > > list I am unable to boot to fully boot a uImage built with these > > patches under Uboot. It appears to hang in very early boot. > > > > > > Here is the output: > > => tftp 400000 > > sequoia/uImage ENET Speed is 100 Mbps - FULL duplex connection > > (EMAC0) Using ppc_4xx_eth0 > > device TFTP from server 9.53.41.24; our IP address is > > 9.53.41.38 Filename > > 'sequoia/uImage'. Load address: > > 0x400000 Loading: > > ################################################################# > > ################################################################# > > ################################################################# > > ####################### > > done Bytes transferred = 1112434 (10f972 > > hex) => bootm > > 400000 ## Booting image at > > 00400000 ... Image Name: > > Linux-2.6.23-rc2 Image Type: PowerPC Linux Kernel Image (gzip > > compressed) Data Size: 1112370 Bytes = 1.1 > > MB Load Address: > > 00000000 Entry Point: > > 00000000 Verifying Checksum ... > > OK Uncompressing Kernel Image ... OK > > > > _______________________________________________ > > Linuxppc-dev mailing list > > Linuxppc-dev@ozlabs.org > > https://ozlabs.org/mailman/listinfo/linuxppc-dev > > This seems to be a wrong image.. > > Are you using "make zImage" ? > > The proper uImage after that command would be smth like cuImage* then... > _______________________________________________ Linuxppc-dev mailing list Linuxppc-dev@ozlabs.org https://ozlabs.org/mailman/listinfo/linuxppc-dev
