Hi Caesar,

Am Mittwoch, 10. September 2014, 10:49:05 schrieb Caesar Wang:
> Hi Heiko,
> 
> 在 2014年09月09日 19:37, Heiko Stübner 写道:
> > Am Mittwoch, 3. September 2014, 10:10:38 schrieb Caesar Wang:
> >> Signed-off-by: Caesar Wang <caesar.w...@rock-chips.com>
> >> ---
> >> 
> >>   arch/arm/boot/dts/rk3288.dtsi | 18 ++++++++++++++++++
> >>   1 file changed, 18 insertions(+)
> >> 
> >> diff --git a/arch/arm/boot/dts/rk3288.dtsi
> >> b/arch/arm/boot/dts/rk3288.dtsi
> >> index 36be7bb..3d672e3 100644
> >> --- a/arch/arm/boot/dts/rk3288.dtsi
> >> +++ b/arch/arm/boot/dts/rk3288.dtsi

[...]

> >> @@ -611,5 +622,12 @@
> >> 
> >>                            rockchip,pins = <5 15 3 &pcfg_pull_none>;
> >>                    
> >>                    };
> >>            
> >>            };
> >> 
> >> +
> >> +          tsadc {
> >> +                  tsadc_int: tsadc-int {
> >> +                          rockchip,pins = <0 10 RK_FUNC_1 &pcfg_pull_up>;
> >> +                  };
> >> +          };
> > 
> > After looking this up in the schematics I see that this is the
> > overtemperature-protection output pin ... labeled OTP_OUT.
> > So I'd think the pinconfig should reflect this pin-name, especially as
> > tsadc-int suggests, that this would be an interrupt leading into the
> > tsadc, while in fact it is an output to a separate circuit.
> 
> Maybe,I guess  your mean as the follows .
> Please correct it and  Laugh out if I got it wrong.

I'll never laugh ... just try get the best solution / trying to understand 
backgrounds.

> 
> tsadc {
>              otp_out: otp-out {
>                  rockchip,pins = <0 10 RK_FUNC_GPIO &pcfg_pull_none>;
>              };
> 
>              tsadc_int: tsadc-int {
>                  rockchip,pins = <0 10 RK_FUNC_1 &pcfg_pull_none>;
>              };
>          };
> Then,I deal with the otp_out in thermal driver.
> I believe The "otp_out" will restart board if it's a high active.
> 
> tsadc_int: tsadc-int {
> +                             rockchip,pins = <0 10 RK_FUNC_1 &pcfg_pull_up>;
> +                     };
> 
> But,I think the about will be implemented in thermal driver.

I only meant the pin name (tsadc-int -> otp-out). In the schmatics the pin 
(controlled by the tsadc) is labeled otp_out and leads to the overtemperature 
protection circuit as expected. And as it's controlled by the tsadc, it should 
of course stay as the desired func_1.


Heiko
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majord...@vger.kernel.org
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/

Reply via email to