Hi Heiko,
在 2014年09月09日 19:37, Heiko Stübner 写道:
Am Mittwoch, 3. September 2014, 10:10:38 schrieb Caesar Wang:
Signed-off-by: Caesar Wang <caesar.w...@rock-chips.com>
---
arch/arm/boot/dts/rk3288.dtsi | 18 ++++++++++++++++++
1 file changed, 18 insertions(+)
diff --git a/arch/arm/boot/dts/rk3288.dtsi b/arch/arm/boot/dts/rk3288.dtsi
index 36be7bb..3d672e3 100644
--- a/arch/arm/boot/dts/rk3288.dtsi
+++ b/arch/arm/boot/dts/rk3288.dtsi
@@ -224,6 +224,17 @@
status = "disabled";
};
+ tsadc: tsadc@ff280000 {
please keep the list of nodes sorted by register address. So when looking at
my v3.18-next/dts branch, it should be after uart4: serial@ff1c0000 and before
usb_host0_ehci: usb@ff500000 .
oh...,I will fix it.
+ compatible = "rockchip,rk3288-tsadc";
+ reg = <0xff280000 0x100>;
+ interrupts = <GIC_SPI 37 IRQ_TYPE_LEVEL_HIGH>;
+ clocks = <&cru SCLK_TSADC>, <&cru PCLK_TSADC>;
+ clock-names = "tsadc", "apb_pclk";
+ pinctrl-names = "default";
+ pinctrl-1 = <&tsadc_int>;
+ status = "disabled";
+ };
+
/* NOTE: ohci@ff520000 doesn't actually work on hardware */
usb_hsic: usb@ff5c0000 {
@@ -611,5 +622,12 @@
rockchip,pins = <5 15 3 &pcfg_pull_none>;
};
};
+
+ tsadc {
+ tsadc_int: tsadc-int {
+ rockchip,pins = <0 10 RK_FUNC_1 &pcfg_pull_up>;
+ };
+ };
After looking this up in the schematics I see that this is the
overtemperature-protection output pin ... labeled OTP_OUT.
So I'd think the pinconfig should reflect this pin-name, especially as tsadc-int
suggests, that this would be an interrupt leading into the tsadc, while in
fact it is an output to a separate circuit.
Maybe,I guess your mean as the follows .
Please correct it and Laugh out if I got it wrong.
tsadc {
otp_out: otp-out {
rockchip,pins = <0 10 RK_FUNC_GPIO &pcfg_pull_none>;
};
tsadc_int: tsadc-int {
rockchip,pins = <0 10 RK_FUNC_1 &pcfg_pull_none>;
};
};
Then,I deal with the otp_out in thermal driver.
I believe The "otp_out" will restart board if it's a high active.
tsadc_int: tsadc-int {
+ rockchip,pins = <0 10 RK_FUNC_1 &pcfg_pull_up>;
+ };
But,I think the about will be implemented in thermal driver.
Heiko
--
Best regards,
Caesar
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majord...@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
