On 07/05/2013 01:46 PM, Jonas Jensen wrote:
> This patch adds an clocksource driver for the main timer(s)
> found on MOXA ART SoCs.
>
> Signed-off-by: Jonas Jensen <[email protected]>
> ---
>
> Notes:
> Applies to next-20130703
>
> Changes since v6:
>
> 1. remove TIMER_CR read back
> 2. set TIMER_CR from constants
>
Except for the few comments below, it looks ok for me.
[ ... ]
> + */
> +#define TIMEREG_CR_1_ENABLE (1 << 0)
> +#define TIMEREG_CR_1_CLOCK (1 << 1)
> +#define TIMEREG_CR_1_INT (1 << 2)
> +#define TIMEREG_CR_2_ENABLE (1 << 3)
> +#define TIMEREG_CR_2_CLOCK (1 << 4)
> +#define TIMEREG_CR_2_INT (1 << 5)
> +#define TIMEREG_CR_3_ENABLE (1 << 6)
> +#define TIMEREG_CR_3_CLOCK (1 << 7)
> +#define TIMEREG_CR_3_INT (1 << 8)
> +#define TIMEREG_CR_COUNT_UP (1 << 9)
> +#define TIMEREG_CR_COUNT_DOWN (0 << 9)
Could you replace this by the BIT macro ?
[ ... ]
> +
> + irq = irq_of_parse_and_map(node, 0);
> + if (irq <= 0)
> + panic("%s: irq_of_parse_and_map failed\n", node->full_name);
> +
> + ret = setup_irq(irq, &moxart_timer_irq);
> + if (ret)
> + panic("%s: setup_irq failed\n", node->full_name);
> +
> + clk = of_clk_get(node, 0);
> + if (IS_ERR(clk))
> + panic("%s: of_clk_get failed\n", node->full_name);
> +
> + pclk = clk_get_rate(clk);
> +
> + if (clocksource_mmio_init(base + TIMER2_BASE + REG_COUNT,
> + "moxart_timer", pclk, 200, 32,
> + clocksource_mmio_readl_down))
> + panic("%s: clocksource_mmio_init failed\n", node->full_name);
> +
> + clock_count_per_tick = DIV_ROUND_CLOSEST(pclk, HZ);
> +
> + writel(~0, base + TIMER2_BASE + REG_LOAD);
> + writel(TIMEREG_CR_2_ENABLE, base + TIMER_CR);
> +
> + moxart_clockevent.cpumask = cpumask_of(0);
moxart_clockevent.irq = irq;
> +
> + /*
> + * documentation is not publicly available:
> + * min_delta / max_delta obtained by trial-and-error,
> + * max_delta 0xfffffffe should be ok because count
> + * register size is u32
> + */
> + clockevents_config_and_register(&moxart_clockevent, pclk,
> + 0x4, 0xfffffffe);
> +}
> +CLOCKSOURCE_OF_DECLARE(moxart, "moxa,moxart-timer", moxart_timer_init);
Thanks
-- Daniel
--
<http://www.linaro.org/> Linaro.org │ Open source software for ARM SoCs
Follow Linaro: <http://www.facebook.com/pages/Linaro> Facebook |
<http://twitter.com/#!/linaroorg> Twitter |
<http://www.linaro.org/linaro-blog/> Blog
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to [email protected]
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
