While converting the boards inside OpenWrt to OF I noticed that the we are
missing a pinconf parameter to set a pin to output.
Signed-off-by: John Crispin <blo...@openwrt.org>
---
drivers/pinctrl/pinctrl-lantiq.h | 1 +
drivers/pinctrl/pinctrl-xway.c | 14 ++++++++++++++
2 files changed, 15 insertions(+)
diff --git a/drivers/pinctrl/pinctrl-lantiq.h b/drivers/pinctrl/pinctrl-lantiq.h
index 4419d32..6d07f02 100644
--- a/drivers/pinctrl/pinctrl-lantiq.h
+++ b/drivers/pinctrl/pinctrl-lantiq.h
@@ -34,6 +34,7 @@ enum ltq_pinconf_param {
LTQ_PINCONF_PARAM_OPEN_DRAIN,
LTQ_PINCONF_PARAM_DRIVE_CURRENT,
LTQ_PINCONF_PARAM_SLEW_RATE,
+ LTQ_PINCONF_PARAM_OUTPUT,
};
struct ltq_cfg_param {
diff --git a/drivers/pinctrl/pinctrl-xway.c b/drivers/pinctrl/pinctrl-xway.c
index aa4c8b8..b23b895 100644
--- a/drivers/pinctrl/pinctrl-xway.c
+++ b/drivers/pinctrl/pinctrl-xway.c
@@ -466,6 +466,11 @@ static int xway_pinconf_get(struct pinctrl_dev *pctldev,
*config = LTQ_PINCONF_PACK(param, 1);
break;
+ case LTQ_PINCONF_PARAM_OUTPUT:
+ reg = GPIO_DIR(pin);
+ *config = LTQ_PINCONF_PACK(param,
+ gpio_getbit(info->membase[0], reg, PORT_PIN(pin)));
+ break;
default:
dev_err(pctldev->dev, "Invalid config param %04x\n", param);
return -ENOTSUPP;
@@ -515,6 +520,14 @@ static int xway_pinconf_set(struct pinctrl_dev *pctldev,
dev_err(pctldev->dev, "Invalid pull value %d\n", arg);
break;
+ case LTQ_PINCONF_PARAM_OUTPUT:
+ reg = GPIO_DIR(pin);
+ if (arg == 0)
+ gpio_clearbit(info->membase[0], reg, PORT_PIN(pin));
+ else
+ gpio_setbit(info->membase[0], reg, PORT_PIN(pin));
+ break;
+
default:
dev_err(pctldev->dev, "Invalid config param %04x\n", param);
return -ENOTSUPP;
@@ -573,6 +586,7 @@ static inline int xway_mux_apply(struct pinctrl_dev
*pctrldev,
static const struct ltq_cfg_param xway_cfg_params[] = {
{"lantiq,pull", LTQ_PINCONF_PARAM_PULL},
{"lantiq,open-drain", LTQ_PINCONF_PARAM_OPEN_DRAIN},
+ {"lantiq,output", LTQ_PINCONF_PARAM_OUTPUT},
};
static struct ltq_pinmux_info xway_info = {
--
1.7.10.4
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majord...@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
