The JMPRS register on Malta boards keeps a 32-bit CPU-endian
value. The readw() function assumes that the value it reads is a
little-endian 16-bit number. Therefore, using readw() to obtain
the value of the JMPRS register is a mistake. This error leads
to incorrect reading of the PCI clock frequency on big-endian
during board start-up.
Change readw() to __raw_readl().
This was tested by injecting a call to printk() and verifying
that the value of the jmpr variable was consistent with current
setting of the JP4 "PCI CLK" jumper.
Signed-off-by: Dmitri Vorobiev <[EMAIL PROTECTED]>
---
arch/mips/mips-boards/malta/malta_setup.c | 2 +-
1 files changed, 1 insertions(+), 1 deletions(-)
diff --git a/arch/mips/mips-boards/malta/malta_setup.c
b/arch/mips/mips-boards/malta/malta_setup.c
index 9a2636e..bc43a5c 100644
--- a/arch/mips/mips-boards/malta/malta_setup.c
+++ b/arch/mips/mips-boards/malta/malta_setup.c
@@ -149,7 +149,7 @@ void __init plat_mem_setup(void)
/* Check PCI clock */
{
unsigned int __iomem *jmpr_p = (unsigned int *)
ioremap(MALTA_JMPRS_REG, sizeof(unsigned int));
- int jmpr = (readw(jmpr_p) >> 2) & 0x07;
+ int jmpr = (__raw_readl(jmpr_p) >> 2) & 0x07;
static const int pciclocks[] __initdata = {
33, 20, 25, 30, 12, 16, 37, 10
};
--
1.5.3
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to [EMAIL PROTECTED]
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
