Hi Fabio, > I am sorry, I fear I don't understand, checkpatch.sh script says the patch is > ok. > Where have I to add a ' ' (a blank?)? > > thank you, > > fabio >
I'm only responding to this because this email is doing a very good job of avoiding my filters somehow :) I think what Greg means is: Change this: /* -op_mode -Set to 0 (HT pure) under the following conditions - - all STAs in the BSS are 20/40 MHz HT in 20/40 MHz BSS or - - all STAs in the BSS are 20 MHz HT in 20 MHz BSS -Set to 1 (HT non-member protection) if there may be non-HT STAs - in both the primary and the secondary channel -Set to 2 if only HT STAs are associated in BSS, - however and at least one 20 MHz HT STA is associated -Set to 3 (HT mixed mode) when one or more non-HT STAs are associated - (currently non-GF HT station is considered as non-HT STA also) -*/ + *op_mode + *Set to 0 (HT pure) under the following conditions + * - all STAs in the BSS are 20/40 MHz HT in 20/40 MHz BSS or + * - all STAs in the BSS are 20 MHz HT in 20 MHz BSS + *Set to 1 (HT non-member protection) if there may be non-HT STAs + * in both the primary and the secondary channel + *Set to 2 if only HT STAs are associated in BSS, + * however and at least one 20 MHz HT STA is associated + *Set to 3 (HT mixed mode) when one or more non-HT STAs are associated + * (currently non-GF HT station is considered as non-HT STA also) + */ to this: /* -op_mode -Set to 0 (HT pure) under the following conditions - - all STAs in the BSS are 20/40 MHz HT in 20/40 MHz BSS or - - all STAs in the BSS are 20 MHz HT in 20 MHz BSS -Set to 1 (HT non-member protection) if there may be non-HT STAs - in both the primary and the secondary channel -Set to 2 if only HT STAs are associated in BSS, - however and at least one 20 MHz HT STA is associated -Set to 3 (HT mixed mode) when one or more non-HT STAs are associated - (currently non-GF HT station is considered as non-HT STA also) -*/ + * op_mode + * Set to 0 (HT pure) under the following conditions + * - all STAs in the BSS are 20/40 MHz HT in 20/40 MHz BSS or + * - all STAs in the BSS are 20 MHz HT in 20 MHz BSS + * Set to 1 (HT non-member protection) if there may be non-HT STAs + * in both the primary and the secondary channel + * Set to 2 if only HT STAs are associated in BSS, + * however and at least one 20 MHz HT STA is associated + * Set to 3 (HT mixed mode) when one or more non-HT STAs are associated + * (currently non-GF HT station is considered as non-HT STA also) + * / Like Dan said, you need a space after the '*'/ Is mise le meas/Regards, Eric Curtin Check out this charity that's close to my heart: https://www.idonate.ie/fundraiser/11394438_peak-for-pat.html https://www.facebook.com/Peak-for-Pat-104470678280309 https://www.instagram.com/peakforpat/
