On Mon, Feb 01, 2021 at 03:30:43PM +0800, zhangqiumi...@huawei.com wrote:
> From: Qiumiao Zhang <zhangqiumi...@huawei.com>
> 
> make pl011 serial port support 485 mode full duplex communication
> 
> Signed-off-by: Qiumiao Zhang <zhangqiumi...@huawei.com>
> ---
> Changes in v4:
>   -Add a bound to the loop in pl011_stop_tx
>   -Remove extra curly braces in pl011_stop_tx
> 
> Changes in v3:
>   -Fix busy loop forever in pl011_tx_empty
>   -Move the definition of cr into uart_amba_port
>   -Run checkpatch with no error or warning
> 
> Changes in v2:
>   -Fix two compilation errors
> 
>  drivers/tty/serial/amba-pl011.c | 38 ++++++++++++++++++++++++++++++++++++++
>  1 file changed, 38 insertions(+)
> 
> diff --git a/drivers/tty/serial/amba-pl011.c b/drivers/tty/serial/amba-pl011.c
> index c255476..026add3 100644
> --- a/drivers/tty/serial/amba-pl011.c
> +++ b/drivers/tty/serial/amba-pl011.c
> @@ -44,6 +44,7 @@
> 
>  #include "amba-pl011.h"
> 
> +#define ISEMPTY                      1
>  #define UART_NR                      14
> 
>  #define SERIAL_AMBA_MAJOR    204
> @@ -264,6 +265,7 @@ struct uart_amba_port {
>       unsigned int            fifosize;       /* vendor-specific */
>       unsigned int            old_cr;         /* state during shutdown */
>       unsigned int            fixed_baud;     /* vendor-set fixed baud rate */
> +     unsigned int            cr;
>       char                    type[12];
>  #ifdef CONFIG_DMA_ENGINE
>       /* DMA stuff */
> @@ -1284,14 +1286,33 @@ static inline bool pl011_dma_rx_running(struct 
> uart_amba_port *uap)
>  #define pl011_dma_flush_buffer       NULL
>  #endif
> 
> +static unsigned int pl011_tx_empty(struct uart_port *port);
> +
>  static void pl011_stop_tx(struct uart_port *port)
>  {
> +     unsigned int count = 1000000;    /* 1s */

1 second of what?

>       struct uart_amba_port *uap =
>           container_of(port, struct uart_amba_port, port);
> 
>       uap->im &= ~UART011_TXIM;
>       pl011_write(uap->im, uap, REG_IMSC);
>       pl011_dma_tx_stop(uap);
> +     if (port->rs485.flags & SER_RS485_ENABLED) {
> +             while(pl011_tx_empty(port) != ISEMPTY && count) {
> +                     count--;
> +                     cpu_relax();
> +                     udelay(1);

Why relax and delay?

And always run checkpatch on your change before sending it out next
time.

thanks,

greg k-h

Reply via email to