> > I have a mirrored boot drive in a pair of firewalls / routers and to test
> > before I put them into service I pulled hda and the machine booted fine
> > from hdc and baring winging about the missing disk (all the drives are
> > mirrored) carried on as normal. A fresh disk was put and rebuilt no
> > problems and was then booted off with the other disk missing.
>
> Ahh. What I was missing was that by specifying /dev/md0 as the root device,
> not only do you get an identical map for the kernels, but the root device
> remains /dev/md0 no matter which drive fails and LILO/kernel don't need to
> do anything special to find it. This assumes the BIOS can boot from /dev/hdc
> to start with (i.e. /dev/hda is totally gone).
Hence I have the disks in caddies to make taking them out all together
easier, to force the bios to find the /dev/hdc as the boot drive
> How does MD/RAID0 know which array should be /dev/md0? What if you had a
> second array on /dev/hdb and /dev/hdd, would that become /dev/md0 (assuming
> it had a kernel/boot sector)?
/etc/raidtab specifies which drives belong in which array, but I only have
hda and hdc so I can't really answer the question
--
Tim Fletcher - Network manager .~.
/V\ L I N U X
[EMAIL PROTECTED] // \\ >Don't fear the penguin<
[EMAIL PROTECTED] /( )\
irc: Night-Shade on quakenet ^^-^^
Never apply a StarTrek solution to a Babylon 5 problem
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to [EMAIL PROTECTED]
Please read the FAQ at http://www.tux.org/lkml/
