Hi,
[...]
On 10/5/20 9:01 PM, Pratyush Yadav wrote:
> +static int spi_nor_cypress_octal_dtr_enable(struct spi_nor *nor, bool enable)
> +{
> + struct spi_mem_op op;
> + u8 *buf = nor->bouncebuf;
> + int ret;
> +
> + if (enable) {
> + /* Use 24 dummy cycles for memory array reads. */
> + ret = spi_nor_write_enable(nor);
> + if (ret)
> + return ret;
> +
> + *buf = SPINOR_REG_CYPRESS_CFR2V_MEMLAT_11_24;
> + op = (struct spi_mem_op)
> + SPI_MEM_OP(SPI_MEM_OP_CMD(SPINOR_OP_WR_ANY_REG, 1),
> + SPI_MEM_OP_ADDR(3, SPINOR_REG_CYPRESS_CFR2V,
> + 1),
> + SPI_MEM_OP_NO_DUMMY,
> + SPI_MEM_OP_DATA_OUT(1, buf, 1));
> +
> + ret = spi_mem_exec_op(nor->spimem, &op);
> + if (ret)
> + return ret;
> +
> + ret = spi_nor_wait_till_ready(nor);
> + if (ret)
> + return ret;
> +
> + nor->read_dummy = 24;
> + }
> +
> + /* Set/unset the octal and DTR enable bits. */
> + ret = spi_nor_write_enable(nor);
> + if (ret)
> + return ret;
> +
> + if (enable)
> + *buf = SPINOR_REG_CYPRESS_CFR5V_OCT_DTR_EN;
> + else
> + *buf = SPINOR_REG_CYPRESS_CFR5V_OCT_DTR_DS;
> +
> + op = (struct spi_mem_op)
> + SPI_MEM_OP(SPI_MEM_OP_CMD(SPINOR_OP_WR_ANY_REG, 1),
> + SPI_MEM_OP_ADDR(enable ? 3 : 4,
> + SPINOR_REG_CYPRESS_CFR5V,
> + 1),
> + SPI_MEM_OP_NO_DUMMY,
> + SPI_MEM_OP_DATA_OUT(1, buf, 1));
> +
> + if (!enable)
> + spi_nor_spimem_setup_op(nor, &op, SNOR_PROTO_8_8_8_DTR);
> +
> + ret = spi_mem_exec_op(nor->spimem, &op);
> + if (ret)
> + return ret;
> +
> + /* Give some time for the mode change to take place. */
> + usleep_range(1000, 1500);
> +
This delay is no longer needed right? I can drop it while applying, if
you confirm.
Tudor: Could you provide your R-by?
Regards
Vignesh
