From: Stephan Gerhold <[email protected]>
[ Upstream commit e6859ae8603c5946b8f3ecbd9b4f02b72955b9d0 ]
Commit fe2aff0c574d2 ("arm64: dts: qcom: msm8916: remove unit name for thermal
trip points")
removed the unit names for most of the thermal trip points defined
in msm8916.dtsi, but missed to update the one for cpu0_1-thermal.
So why wasn't this spotted by "make dtbs_check"? Apparently, the name
of the thermal zone is already invalid: thermal-zones.yaml specifies
a regex of ^[a-zA-Z][a-zA-Z0-9\\-]{1,12}-thermal$, so it is not allowed
to contain underscores. Therefore the thermal zone was never verified
using the DTB schema.
After replacing the underscore in the thermal zone name, the warning
shows up:
apq8016-sbc.dt.yaml: thermal-zones: cpu0-1-thermal:trips: 'trip-point@0'
does not match any of the regexes: '^[a-zA-Z][a-zA-Z0-9\\-_]{0,63}$',
'pinctrl-[0-9]+'
Fix up the thermal zone names and remove the unit name for the trip point.
Cc: Amit Kucheria <[email protected]>
Fixes: fe2aff0c574d2 ("arm64: dts: qcom: msm8916: remove unit name for thermal
trip points")
Signed-off-by: Stephan Gerhold <[email protected]>
Link: https://lore.kernel.org/r/[email protected]
Signed-off-by: Bjorn Andersson <[email protected]>
Signed-off-by: Sasha Levin <[email protected]>
---
arch/arm64/boot/dts/qcom/msm8916.dtsi | 6 +++---
1 file changed, 3 insertions(+), 3 deletions(-)
diff --git a/arch/arm64/boot/dts/qcom/msm8916.dtsi
b/arch/arm64/boot/dts/qcom/msm8916.dtsi
index 32bd140ac9fd4..729d36ff2e247 100644
--- a/arch/arm64/boot/dts/qcom/msm8916.dtsi
+++ b/arch/arm64/boot/dts/qcom/msm8916.dtsi
@@ -228,14 +228,14 @@ pmu {
};
thermal-zones {
- cpu0_1-thermal {
+ cpu0-1-thermal {
polling-delay-passive = <250>;
polling-delay = <1000>;
thermal-sensors = <&tsens 5>;
trips {
- cpu0_1_alert0: trip-point@0 {
+ cpu0_1_alert0: trip-point0 {
temperature = <75000>;
hysteresis = <2000>;
type = "passive";
@@ -258,7 +258,7 @@ map0 {
};
};
- cpu2_3-thermal {
+ cpu2-3-thermal {
polling-delay-passive = <250>;
polling-delay = <1000>;
--
2.25.1
