Add binding documentation for mmc host controllers present on
TI's J7200 SOC
Signed-off-by: Faiz Abbas <faiz_ab...@ti.com>
---
Documentation/devicetree/bindings/mmc/sdhci-am654.txt | 6 +++++-
1 file changed, 5 insertions(+), 1 deletion(-)
diff --git a/Documentation/devicetree/bindings/mmc/sdhci-am654.txt
b/Documentation/devicetree/bindings/mmc/sdhci-am654.txt
index 6d202f4d9249..b49cbfdd679f 100644
--- a/Documentation/devicetree/bindings/mmc/sdhci-am654.txt
+++ b/Documentation/devicetree/bindings/mmc/sdhci-am654.txt
@@ -12,6 +12,8 @@ Required Properties:
"ti,am654-sdhci-5.1": SDHCI on AM654 device.
"ti,j721e-sdhci-8bit": 8 bit SDHCI on J721E device.
"ti,j721e-sdhci-4bit": 4 bit SDHCI on J721E device.
+ "ti,j7200-sdhci-8bit": 8 bit SDHCI on J7200 device.
+ "ti,j7200-sdhci-4bit": 4 bit SDHCI on J7200 device.
- reg: Must be two entries.
- The first should be the sdhci register space
- The second should the subsystem/phy register space
@@ -33,7 +35,9 @@ Required Properties:
These bindings must be provided otherwise the driver will disable the
corresponding speed mode (i.e. all nodes must provide at least
-legacy)
-Optional Properties (Required for ti,am654-sdhci-5.1 and ti,j721e-sdhci-8bit):
+Optional Properties (Required for ti,am654-sdhci-5.1,
+ ti,j721e-sdhci-8bit,
+ ti,j7200-sdhci-8bit):
- ti,trm-icp: DLL trim select
- ti,driver-strength-ohm: driver strength in ohms.
Valid values are 33, 40, 50, 66 and 100 ohms.
--
2.17.1
