[PATCH v3] pwm: bcm-iproc: handle clk_get_rate() return

[Scott Branden]

From: Rayagonda Kokatanur <rayagonda.kokata...@broadcom.com>

Handle clk_get_rate() returning 0 to avoid possible division by zero.

Fixes: daa5abc41c80 ("pwm: Add support for Broadcom iProc PWM controller")
Signed-off-by: Rayagonda Kokatanur <rayagonda.kokata...@broadcom.com>
Signed-off-by: Scott Branden <scott.bran...@broadcom.com>
Reviewed-off-by: Ray Jui <ray....@broadcom.com>

---
Changes from v2: update commit message to remove <= condition
as clk_get_rate only returns value >= 0
---
 drivers/pwm/pwm-bcm-iproc.c | 9 +++++++--
 1 file changed, 7 insertions(+), 2 deletions(-)

diff --git a/drivers/pwm/pwm-bcm-iproc.c b/drivers/pwm/pwm-bcm-iproc.c
index 1f829edd8ee7..d392a828fc49 100644
--- a/drivers/pwm/pwm-bcm-iproc.c
+++ b/drivers/pwm/pwm-bcm-iproc.c
@@ -85,8 +85,6 @@ static void iproc_pwmc_get_state(struct pwm_chip *chip, 
struct pwm_device *pwm,
        u64 tmp, multi, rate;
        u32 value, prescale;
 
-       rate = clk_get_rate(ip->clk);
-
        value = readl(ip->base + IPROC_PWM_CTRL_OFFSET);
 
        if (value & BIT(IPROC_PWM_CTRL_EN_SHIFT(pwm->hwpwm)))
@@ -99,6 +97,13 @@ static void iproc_pwmc_get_state(struct pwm_chip *chip, 
struct pwm_device *pwm,
        else
                state->polarity = PWM_POLARITY_INVERSED;
 
+       rate = clk_get_rate(ip->clk);
+       if (rate == 0) {
+               state->period = 0;
+               state->duty_cycle = 0;
+               return;
+       }
+
        value = readl(ip->base + IPROC_PWM_PRESCALE_OFFSET);
        prescale = value >> IPROC_PWM_PRESCALE_SHIFT(pwm->hwpwm);
        prescale &= IPROC_PWM_PRESCALE_MAX;
-- 
2.17.1