Hi Sivaprakash,
Sivaprakash Murugesan <sivap...@codeaurora.org> wrote on Fri, 12 Jun
2020 12:19:48 +0530:
> SFLASHC_BURST_CFG is only available on older ipq nand platforms, this
> register has been removed when the NAND controller is moved as part of qpic
> controller.
>
> avoid register writes to this register on devices which are based on qpic
Avoid writing this register on ...
> NAND controllers.
>
> Fixes: a0637834 (mtd: nand: qcom: support for IPQ4019 QPIC NANDcontroller)
> Fixes: dce84760 (mtd: nand: qcom: Support for IPQ8074 QPIC NAND controller)
I don't think having two Fixes tag is allowed. Take the older one
instead.
> Cc: sta...@vger.kernel.org
> Signed-off-by: Sivaprakash Murugesan <sivap...@codeaurora.org>
> ---
> [V3]
> * Addressed Miquel comments, added flag based on nand controller hw
> to avoid the register writes to specific ipq platforms
> drivers/mtd/nand/raw/qcom_nandc.c | 8 +++++++-
> 1 file changed, 7 insertions(+), 1 deletion(-)
>
> diff --git a/drivers/mtd/nand/raw/qcom_nandc.c
> b/drivers/mtd/nand/raw/qcom_nandc.c
> index f1daf33..e0c55bb 100644
> --- a/drivers/mtd/nand/raw/qcom_nandc.c
> +++ b/drivers/mtd/nand/raw/qcom_nandc.c
> @@ -459,11 +459,13 @@ struct qcom_nand_host {
> * among different NAND controllers.
> * @ecc_modes - ecc mode for NAND
> * @is_bam - whether NAND controller is using BAM
> + * @is_qpic - whether NAND CTRL is part of qpic IP
> * @dev_cmd_reg_start - NAND_DEV_CMD_* registers starting offset
> */
> struct qcom_nandc_props {
> u32 ecc_modes;
> bool is_bam;
> + bool is_qpic;
> u32 dev_cmd_reg_start;
> };
>
> @@ -2774,7 +2776,8 @@ static int qcom_nandc_setup(struct qcom_nand_controller
> *nandc)
> u32 nand_ctrl;
>
> /* kill onenand */
> - nandc_write(nandc, SFLASHC_BURST_CFG, 0);
> + if (!nandc->props->is_qpic)
> + nandc_write(nandc, SFLASHC_BURST_CFG, 0);
> nandc_write(nandc, dev_cmd_reg_addr(nandc, NAND_DEV_CMD_VLD),
> NAND_DEV_CMD_VLD_VAL);
>
> @@ -3029,18 +3032,21 @@ static int qcom_nandc_remove(struct platform_device
> *pdev)
> static const struct qcom_nandc_props ipq806x_nandc_props = {
> .ecc_modes = (ECC_RS_4BIT | ECC_BCH_8BIT),
> .is_bam = false,
> + .is_qpic = false,
This line is unneeded.
> .dev_cmd_reg_start = 0x0,
> };
>
> static const struct qcom_nandc_props ipq4019_nandc_props = {
> .ecc_modes = (ECC_BCH_4BIT | ECC_BCH_8BIT),
> .is_bam = true,
> + .is_qpic = true,
> .dev_cmd_reg_start = 0x0,
> };
>
> static const struct qcom_nandc_props ipq8074_nandc_props = {
> .ecc_modes = (ECC_BCH_4BIT | ECC_BCH_8BIT),
> .is_bam = true,
> + .is_qpic = true,
> .dev_cmd_reg_start = 0x7000,
> };
>
Much better patch IMHO, just a few nits and we'll be good.
Thanks,
Miquèl
