The "Required properties:" section is copied verbatim for each of the two
supported chips. In preparation to add a new chip variant make it a common
section and keep the two examples to differentiate between the two chips.

Signed-off-by: Luca Ceresoli <l...@lucaceresoli.net>
---
 .../devicetree/bindings/mfd/lp87565.txt       | 21 ++++---------------
 1 file changed, 4 insertions(+), 17 deletions(-)

diff --git a/Documentation/devicetree/bindings/mfd/lp87565.txt 
b/Documentation/devicetree/bindings/mfd/lp87565.txt
index 41671e0dc26b..b75ae23a1ef3 100644
--- a/Documentation/devicetree/bindings/mfd/lp87565.txt
+++ b/Documentation/devicetree/bindings/mfd/lp87565.txt
@@ -1,7 +1,7 @@
 TI LP87565 PMIC MFD driver
 
 Required properties:
-  - compatible:        "ti,lp87565", "ti,lp87565-q1"
+  - compatible:                one of "ti,lp87565", "ti,lp87565-q1", 
"ti,lp87561-q1"
   - reg:               I2C slave address.
   - gpio-controller:   Marks the device node as a GPIO Controller.
   - #gpio-cells:       Should be two.  The first cell is the pin number and
@@ -10,7 +10,8 @@ Required properties:
   - xxx-in-supply:     Phandle to parent supply node of each regulator
                        populated under regulators node. xxx should match
                        the supply_name populated in driver.
-Example:
+
+Example for the TI LP87565-Q1 PMIC (dual 2-phase output configuration):
 
 lp87565_pmic: pmic@60 {
        compatible = "ti,lp87565-q1";
@@ -42,21 +43,7 @@ lp87565_pmic: pmic@60 {
        };
 };
 
-TI LP87561 PMIC:
-
-This is a single output 4-phase regulator configuration
-
-Required properties:
-  - compatible:        "ti,lp87561-q1"
-  - reg:               I2C slave address.
-  - gpio-controller:   Marks the device node as a GPIO Controller.
-  - #gpio-cells:       Should be two.  The first cell is the pin number and
-                       the second cell is used to specify flags.
-                       See ../gpio/gpio.txt for more information.
-  - xxx-in-supply:     Phandle to parent supply node of each regulator
-                       populated under regulators node. xxx should match
-                       the supply_name populated in driver.
-Example:
+Example for the TI LP87561 PMIC (single 4-phase output configuration):
 
 lp87561_pmic: pmic@62 {
        compatible = "ti,lp87561-q1";
-- 
2.27.0

Reply via email to