Hi Dan,
On Fri, Sep 20, 2019 at 06:48:59AM -0500, Dan Murphy wrote:
> Guido
>
> On 9/20/19 12:27 AM, Guido Günther wrote:
> > The driver currently reports successful initialization on every failure
> > as long as it's able to power off the regulator. Don't check the return
> > value of regulator_disable to avoid that.
> >
> > Signed-off-by: Guido Günther <a...@sigxcpu.org>
> > ---
> > drivers/leds/leds-lm3692x.c | 7 ++++---
> > 1 file changed, 4 insertions(+), 3 deletions(-)
> >
> > diff --git a/drivers/leds/leds-lm3692x.c b/drivers/leds/leds-lm3692x.c
> > index 487228c2bed2..31115655f97b 100644
> > --- a/drivers/leds/leds-lm3692x.c
> > +++ b/drivers/leds/leds-lm3692x.c
> > @@ -198,7 +198,7 @@ static int lm3692x_brightness_set(struct led_classdev
> > *led_cdev,
> > static int lm3692x_init(struct lm3692x_led *led)
> > {
> > int enable_state;
> > - int ret;
> > + int ret, ret2;
> > if (led->regulator) {
> > ret = regulator_enable(led->regulator);
> > @@ -313,14 +313,15 @@ static int lm3692x_init(struct lm3692x_led *led)
> > gpiod_direction_output(led->enable_gpio, 0);
> > if (led->regulator) {
> > - ret = regulator_disable(led->regulator);
> > - if (ret)
> > + ret2 = regulator_disable(led->regulator);
> > + if (ret2)
> > dev_err(&led->client->dev,
> > "Failed to disable regulator\n");
>
> s/ret2/reg_ret
>
> Like you did in patch 1 log the error code as well.
>
> If regulator_disabled failed you might want to send that error code but
> either error returned is fine.
Changed in v3 - i opted to return the original error code since this is
likely what upper layers care about and only printk the regulator
failure one.
Thanks for the review,
-- Guido
>
> Dan
>
>
> > }
> > return ret;
> > }
> > +
> > static int lm3692x_probe_dt(struct lm3692x_led *led)
> > {
> > struct fwnode_handle *child = NULL;
>
