From: Bartosz Golaszewski <[email protected]>
If the driver doesn't support open-drain/source config options, we
emulate this behavior when setting the direction by calling
gpiod_direction_input() if the default value is 0 (open-source) or
1 (open-drain), thus not actively driving the line in those cases.
This however clears the FLAG_IS_OUT bit for the GPIO line descriptor
and makes the LINEINFO ioctl() incorrectly report this line's mode as
'input' to user-space.
This commit modifies the ioctl() to always set the GPIOLINE_FLAG_IS_OUT
bit in the lineinfo structure's flags field. Since it's impossible to
use the input mode and open-drain/source options at the same time, we
can be sure the reported information will be correct.
Fixes: 521a2ad6f862 ("gpio: add userspace ABI for GPIO line information")
Cc: stable <[email protected]>
Signed-off-by: Bartosz Golaszewski <[email protected]>
---
drivers/gpio/gpiolib.c | 6 ++++--
1 file changed, 4 insertions(+), 2 deletions(-)
diff --git a/drivers/gpio/gpiolib.c b/drivers/gpio/gpiolib.c
index f497003f119c..80a2a2cb673b 100644
--- a/drivers/gpio/gpiolib.c
+++ b/drivers/gpio/gpiolib.c
@@ -1091,9 +1091,11 @@ static long gpio_ioctl(struct file *filp, unsigned int
cmd, unsigned long arg)
if (test_bit(FLAG_ACTIVE_LOW, &desc->flags))
lineinfo.flags |= GPIOLINE_FLAG_ACTIVE_LOW;
if (test_bit(FLAG_OPEN_DRAIN, &desc->flags))
- lineinfo.flags |= GPIOLINE_FLAG_OPEN_DRAIN;
+ lineinfo.flags |= (GPIOLINE_FLAG_OPEN_DRAIN |
+ GPIOLINE_FLAG_IS_OUT);
if (test_bit(FLAG_OPEN_SOURCE, &desc->flags))
- lineinfo.flags |= GPIOLINE_FLAG_OPEN_SOURCE;
+ lineinfo.flags |= (GPIOLINE_FLAG_OPEN_SOURCE |
+ GPIOLINE_FLAG_IS_OUT);
if (copy_to_user(ip, &lineinfo, sizeof(lineinfo)))
return -EFAULT;
--
2.21.0
