[PATCH] i2c: iproc: Change driver to use 'BIT' macro

[Ray Jui]

Change the iProc I2C driver to use the 'BIT' macro from all '1 << XXX'
bit operations to get rid of compiler warning and improve readability of
the code

Signed-off-by: Ray Jui <ray....@broadcom.com>
---
 drivers/i2c/busses/i2c-bcm-iproc.c | 6 +++---
 1 file changed, 3 insertions(+), 3 deletions(-)

diff --git a/drivers/i2c/busses/i2c-bcm-iproc.c 
b/drivers/i2c/busses/i2c-bcm-iproc.c
index 562942d0c05c..a845b8decac8 100644
--- a/drivers/i2c/busses/i2c-bcm-iproc.c
+++ b/drivers/i2c/busses/i2c-bcm-iproc.c
@@ -717,7 +717,7 @@ static int bcm_iproc_i2c_xfer_single_msg(struct 
bcm_iproc_i2c_dev *iproc_i2c,
 
                        /* mark the last byte */
                        if (i == msg->len - 1)
-                               val |= 1 << M_TX_WR_STATUS_SHIFT;
+                               val |= BIT(M_TX_WR_STATUS_SHIFT);
 
                        iproc_i2c_wr_reg(iproc_i2c, M_TX_OFFSET, val);
                }
@@ -844,7 +844,7 @@ static int bcm_iproc_i2c_cfg_speed(struct bcm_iproc_i2c_dev 
*iproc_i2c)
 
        iproc_i2c->bus_speed = bus_speed;
        val = iproc_i2c_rd_reg(iproc_i2c, TIM_CFG_OFFSET);
-       val &= ~(1 << TIM_CFG_MODE_400_SHIFT);
+       val &= ~BIT(TIM_CFG_MODE_400_SHIFT);
        val |= (bus_speed == 400000) << TIM_CFG_MODE_400_SHIFT;
        iproc_i2c_wr_reg(iproc_i2c, TIM_CFG_OFFSET, val);
 
@@ -995,7 +995,7 @@ static int bcm_iproc_i2c_resume(struct device *dev)
 
        /* configure to the desired bus speed */
        val = iproc_i2c_rd_reg(iproc_i2c, TIM_CFG_OFFSET);
-       val &= ~(1 << TIM_CFG_MODE_400_SHIFT);
+       val &= ~BIT(TIM_CFG_MODE_400_SHIFT);
        val |= (iproc_i2c->bus_speed == 400000) << TIM_CFG_MODE_400_SHIFT;
        iproc_i2c_wr_reg(iproc_i2c, TIM_CFG_OFFSET, val);
 
-- 
2.17.1